I found solution to solve problems with flame cuts...
Пікірлер: 27
@magaliosn8 ай бұрын
Ευχαριστώ πολύ με βοηθήσατε πολύ να λύσω το πρόβλημα μου !!!
@octaviansorescu74278 ай бұрын
Ok! Thank you very much!❤
@miklosvarga86703 ай бұрын
I did the same one, successful one. Thank you
@PaulAntonescu8 ай бұрын
did it ever cut flames again w/o the bumper?
@istvanfejes78157 ай бұрын
I am currently struggling with an Ariston Genus One 5P3 error. I replaced the gas valve, which was clearly full of dirt and the filter was torn. But the 5P3 error is still present with the new gas valve.
@octaviansorescu74278 ай бұрын
Hello! If you didn't put that small black plastic protection, didn't it give error 5P3? Was that little piece blocking the piston? Or don't let the piston open all the way?
@michalaron47848 ай бұрын
Because of loose little bumper, piston can't fully open gas valve, too much air, lack of gas in combustion chamber cause flame cuts
@ryszardidkowiak86258 ай бұрын
Witam, mam od miesiąca ten sam problem. Pytanie czy po likwidacji "zderzaka" błąd 5P3 powrócił po jakimś czasie?
@michalaron47848 ай бұрын
Since removing bumper no flame cuts
@octaviansorescu74278 ай бұрын
What do you call a bumper? That little black plastic piece in the piston head? It's like you chose not to wear it!!!! Or did I not understand correctly? I saw that the piston that regulates the pressure had a small plastic piece. In the end I understood that you didn't put it on the assembly anymore.
@michalaron47848 ай бұрын
Bumper=little black piece, it is kind of rubber material, it's supposed to avoid clicking noise when valve opening, therefore "bumper", I think due aging rubber get shrinking and do not hold in place-in piston.
@mihaicornea59227 ай бұрын
Hello! after all, you still put the Bumper Little black piece, or not?
@michalaron47847 ай бұрын
without bumper
@luk5827Ай бұрын
PCB board it's the problem for all Ariston Alteas / Genus One gas boilers .
@jamespoland30788 ай бұрын
Do you know the fix for fault 503 flame sensed with gas valve closed
@kamen0s223 ай бұрын
hello James, have you found solution for error 503 Flame with gas valve closed ? Thanks
@matiaspitu2 ай бұрын
What product do you use to clean parts?
@michalaron47842 ай бұрын
izopropylalcohol- IPA
@octaviansorescu74278 ай бұрын
Did you put it back or not? Thank you!
@michalaron47848 ай бұрын
I didn't
@giuseppeavellina5088 ай бұрын
Grazie di vero cuore se per favore mi puoi dire se il paraurti lo devo mettere si oppure no grazie di vero cuore
@gerikuper64736 ай бұрын
You silver problem or is still there and you need to fix the pcb part.