how many CFMs compressor you have to use for this project?
@duncanberenger82682 жыл бұрын
this method is environmental friendly than crushed glass
@vijaykumar-jg3vh3 ай бұрын
❤❤❤❤
@peteacher524 жыл бұрын
To victim of tar and feathering; "Over here, Bruno, I'll get you all cleaned up in no time!"
@andredasilvapimenta12943 жыл бұрын
Demora mais ficar bom
@bruceneedles22042 жыл бұрын
Well it works, but you’ll be there for 100 years on one piece of equipment.
@firstnationsindian80623 жыл бұрын
I can't see spending $50-$60k on dry ice equipment when you can purchase dustless blasting for less than half using recycled bottle glass. The crushed glass will cut that tar 3 times as fast.
@3DPeter2 жыл бұрын
There's no way that anything else can blast this off, because the dry ice freezes the tar until it's hard as ice and then it breaks off. When its warm and soft, any blasting aggregate will bounce off.
@stevem10812 жыл бұрын
@@3DPeter I would have to try a steam jenny or a hot water pressure washer, that will soften it up, then the pressure will cut it. I have cut through concrete and rubber with a standard pressure washer.
@3DPeter2 жыл бұрын
@@stevem1081 Btw, there's no way that a standard pressure washer cut through concrete or rubber, and i know because i already had multiple pressure washers in the past 35 years and one of them was even a big and heavy professional machine with a diesel burner to make hot water. It's a pressure washer, not a water jet to cut things who also need sand to make a cut.
@pauloshea37412 жыл бұрын
What about the media and water mess afterwards? What about using on electrics?