No video
Audi A8 cluster testing in simhub - BeamNG
Рет қаралды 333
2 ай бұрынFinally after a long time been able to enjoy a 2013 Audi A8 cluster without that component protection “SAFE” triggering. The game is BeamNG and done using Arduino mega + Seeed studios CAN bus shield. Thanks to the legend !!@Albertt.c
@vampyryannik7334 2 ай бұрын
Oh wow you got one from a w12. Also good thing it's the A8 and not A6, the A6 needs checksums for stuff like transmission
@randomscience4k 2 ай бұрын
Ohh didn’t know about the transmission thing..that’s nice to hear that. To me the A7 & A8 looked the same. Only reason I got this A8 was that it was only $28. Didn’t know it was a W12 either. There was no mention of anything in description apart form it working.
@andersonguimaraes1057 2 ай бұрын
very good I really like using the panel to play
@Superkolos 2 ай бұрын
Nice mate 👍
@randomscience4k 2 ай бұрын
Thank you! 😊
@Hellennnn Ай бұрын
Hello, I really like the work you do. And I have the VW Passat instrument cluster. When I connect it to the adapter, it only shows time and date on the screen. But even though I have the canbus and ardunio module, I cannot receive messages from my cluster in the canhacker program. If possible can you help? respects
@randomscience4k Ай бұрын
Hi, thank you! To power up newer clusters you need the ignition can ID frame and its corresponding bytes to be send to the cluster via Arduino. Now your last sentence isn't very clear, do you mean to find the DTC and can IDs stored in cluster? If yes I think there is a way, but I'm not very familiar with it. We have some folks in my discord channel who are aware of the technique to do this and maybe you can reach out to them and find out. There are members who have VW clusters, so they should be able to help you out.
@Hellennnn Ай бұрын
@@randomscience4k It would be great. There is generally no one interested in VW clusters in Turkey. Just when I was about to give up hope, I came across your videos. Thank you very much.
@Hellennnn Ай бұрын
@@randomscience4k Let me explain it this way. I connected Can Low and Can high. When I say connect after selecting the com port. A message should be sent to the section labeled Receive (Monitor), but it does not. In other words, my Cluster does not connect with my CanBus module. (By the way, my English is not good. I am writing with the help of Google Translate, sorry)
@Hellennnn Ай бұрын
I want to ask one more question. I also use Seedstudio as a CanBus module. Have you soldered anything to the bottom of the board? On the Seedstudio website, it says that soldering is done between the pins, that's why I'm asking. Please forgive my ignorance@@randomscience4k
@randomscience4k Ай бұрын
@Hellennnn no worries..feel free to ask. I don’t check my KZfaq notifications a lot, so there could be delay at time. Myself and another member have responded to your question on discord. Well there is the 120 ohm bridging pad, in my case I cut it when testing an E90 cluster. Else it wouldn’t work. I do not have a vw cluster, but when tested with an Audi a8, I don’t have to bridge it.