This video is about how to setup your Audient Evo 4 to use with Smaart and along with that, how to configure Smaart to use the Audient Evo 4 as the I/O Device.
Along with it also how to use the Loopback feature on the Evo 4 to make the best use of it.
Finally I also provide an insight about my opinion of the Evo 4 as an I/O device with Smaart.
Timestamp :
00:07 : Introduction.
01:27 : Agenda of Video.
02:04 : Step 1 : Connect Your Soundcard and Have cables ready.
03:14 : Step 2 : Start Smaart.
04:09 : Step 3 : Configuring and Labelling I/O in Smaart.
07:30 : Step 4 : Making Physical Connections.
09:05 : Step 5 : Configuring Signal Generator.
09:35 : Step 6 : Verifying connections and Engine.
10:55 : Step 7 : Creating and Configuring TF Engine.
11:20 : Step 8 : Measuring TF.
12:11 : Monitor Mix Control Setting on Evo 4 (Most important setting to avoid system feedback).
13:56 : Understanding Loopback feature on Evo with Smaart.
16:10 : Using Evo Loopback as Virtual Reference in Smaart.
17:33 : Difference in Propagation Delay between Physical and Virtual Reference.
20:22 : Configure to Use 2 mics for measurement with Evo 4.
23:14 : Pro's and Con's.
Note : My Live Mistakes :
1)17:58 : It's 0.5ms and not 0.5 seconds.
2)22:18 : The right choice of word be : Flip the polarity and not Phase.
Thank you So much for watching.
Do Share, Subscribe and Hit Like.