Thanks again! Thanks again for the useful instruction.

You helped me so much!

great lessons...

You highlighted that Acad LT does not allow Constraints. Can the same functionality you presented here be achieved in LT - or do you need to constrain first? Thanks

Hi Brandon, thanks for this information and sharing. You mention doing cabinets and I have watched about 20 ppl do videos on Dynamic blocks, but none of them touch on the issue I am having. I am working on a Kitchen Cabinet (the front frame of the cabinet box), there are 2 upper drawers over an opening for double doors below. To the right are 3 drawers. The drawers are not an issue for me when "stretch" is used, but how do I get the upper drawers to stretch to the right sizes, when I need the left side of the cabinet to stretch? I need the upper drawers to maintain their width, (exact same with for each drawer opening) with 1 3/8" in between. perhaps you have another video out there... Thank you! Lisa

Thank you for this! There is a Test Block inside of the block editor (upper right corner) Do you don't have to save & close everytime.

Wouldn't the equals line constraint eliminate a good chunk of the needed dimensions? I haven't used these features in autocad but, in inventor that would be the cleanest way to so the same.

Thanks sir... Can we write an expression on action parameter? Or there is a lisp that make this?

That is so much helping. Sir, have you tried Revit, Sir?

I can't even describe my relief when you started talking without an Indian accent.

Not really a video should how to use Actual Parameters. This video is strictly Constraints.