Probably due to legal issues with Traxxas

Thank you! Will start shipping orders out on the 29th, and into the new year!

@@kevin_finethat works for me. Thank you and Happy New Year

Yes I have! I have made ones for the unimog! You can find them on my website and Etsy store as well!

Hey feel free to shoot me a message on my website contact form, or through Etsy. I would be happy to help take a look and see what might be the issue! As shown in the video you do have to pull it down with your hands, but not sure if that’s the issue you are having or if it is something different. Sending me photos will definitely help with troubleshooting.

I forgot about pulling it down with my hand part, my goof, ok never mind, and thank you for the response.@@kevin_fine

Yes I do, if you search that on my channel page or go to my website in the description and head to the axial section you’ll find it!

Links are in the video description! Can find it at finelaserdesigns.com

Unfortunately it would not as these are designed for the specific body and respective chassis.

@@kevin_fine Can you make one for me?

@@kevin_fine or what you suggest I use as a body mount. I don't wanna drill holes in my new body.

@@Webb4RC I'm sorry I don't own that body and chassis so other than suggesting the stock body posts and drilling I don't know what else is out there for that truck.

@@Webb4RC I'm sorry I need the truck to make the parts and I unfortunately do not have the time to work on older models.

Yup! As long as they don’t interfere with the area the latch takes up (which is inside the body so highly unlikely). They’ll work just fine!

@@kevin_fine I just installed the clips. Super easy and no more impossible to reach pins. Instructions were very helpful. Thank you!

Formlabs Tough 2000 is stronger than PLA and significantly less brittle. This is engineering grade resin and not the cheap stuff that you might be used to experiencing in the past. You can find all the data sheets for this resin on Formlabs website if you’re curious to learn more about it.

@@kevin_fine I am familiar, definitely. From my experience the PLA pro and + I use is quite strong without the brittle factor of resin, hence why I was wanting files so I can run a PLA or Nylon one instead. If you don't mind I'll take the video into solid works and just put the calipers. Great idea.

@@Cranklotus yea feel free to experiment no issues with that. Just don’t appreciate people who knock off the design to sell cheap or give away, but you’re not going to do that so I truly appreciate it. Wish you best of luck with your experiments. I’ve had great luck with this resin and I’ll honestly be shocked if anybody breaks this design (it’d have to be one heck of a crash to break it).

Sorry I do not sell the files. Since I perform Finite Element Analysis (FEA) on all my designs that means I’m designing for the specific material I’m printing in (this case Formlabs Tough 2000). That means that printing in any of your typical FDM materials would almost certainly result in a bad experience and a non-functioning part. The Tough 2000 resin is stronger than some injection molded materials and it holds up great.

@@kevin_fine nice, looks like it's to solid works I go. Great idea, I'll be printing in carbon reinforced nylon.

I have not looked into that truck at this time, but I can check it out and see if there is enough demand for a design to be made. No promises but will check it out!

The main reason I don't recommend picking it up by the cage is you're putting all the stress through the clipless parts. I design them so they can take it, but over time (many months of use) the parts will stretch and become looser. That's why I made a video on how to reset them with a heat gun. You can pick it up by the cage, but I don't recommend you walk around solely carrying it by the cage. Pick it up by the cage, but then hold it by the chassis once its in the air for example. Hopefully that helps make sense! Let me know if you have further questions always happy to help!