Balancing your RC Street Outlaw Drag Slicks

Рет қаралды 28,191

Күн бұрын

Пікірлер: 33

@ruftime 3 жыл бұрын

Thanks Greg! That topflite balancer has been a good friend for more years than I can remember. From tiny boat props on up😎

@zdattonejones6709 2 жыл бұрын

I just learned something. It's very nice to have this information. Thanks for the information sir.

@bobtierney6946 3 жыл бұрын

any hobby shop that carries RC aircraft will have these. They are a prop ballencer.

@robertsloan4684 2 жыл бұрын

Try solid copper wire from 12-2 romex electrical wire. Super glue the striped copper wire to the inside similar to where you put your putty. I use about 1/8" pieces at a time. And it does t fall out. I do that for touring to drag and all in between. Excellent video.

@covecityboys Жыл бұрын

That balancer doubles as a Turkey call too.

@12R1rcbashr 3 жыл бұрын

Great video man thanks for sharing happy bashing bud.

@richardbrown6762 Ай бұрын

I've been doing this for 20 years now but I never told anyone that 😂😂

@TheBlueberry606 3 жыл бұрын

Great tips

@soundmindtv2911 2 жыл бұрын

Thanks, Gregg. Very helpful. (Nitrous Fed sent me)

@GuitarGuys7299 3 жыл бұрын

R/C car setup's are just as important as a real car.

@patriotrob7066 4 жыл бұрын

We don't balance slicks on real drag cars. Weights won't stay on and to dangerous . I run 8.20s with un balanced rear tires Butt after this video I just ordered those rim's and the outlaw drag tires 👍

@Blownblackknight 3 жыл бұрын

Use stick on weights and thin tape I use a aluminum type tape for this never come off that way.... just make sure tape sticks good never had a problem

@theclan4adventures 2 жыл бұрын

Pretty sure your not pulling 400-800mph in the quarter in your 8.20 car. Even still you should get them balanced with tape and you’ll notice it. Every tiny vibration matters 1:1 cars and even on rc cars.

@Rob-tl9md 2 жыл бұрын

bikes will run 200 with stick on weights.

@mr.h.5205 3 жыл бұрын

I THANK YOU GREAT 👍

@codyalt5871 2 жыл бұрын

Would balancing on the car be better? Tire could be stright but not stright with car?

@terryhildreth9854 3 жыл бұрын

Do you tape your foams to control ballooning

@Speedy123youknowme 3 жыл бұрын

Man we are getting old aren’t we? You have about as much grey as I do! Lmao

@tigweld4you 3 жыл бұрын

👍👍👍

@tigweld4you 3 жыл бұрын

👍👍

@ClipDog 3 жыл бұрын

I definitely learned something from this video, can you tell me where you can get one of those balancers?

@guidelineuk 3 жыл бұрын

That's a no then....🤐

@Gregorybridgewater 3 жыл бұрын

You can get a tire balancer from amain.com

@TroyBest 2 жыл бұрын

You need to balance your balancer. The rod in the middle should float hardly touching the magnets if it touches then at all. Should almost look like a magic act floating in there. Hope that makes sense

@trippegelston6574 2 жыл бұрын

Why do u have holes in your tires

@BoooRocK Жыл бұрын

I checked several videos and nobody shared a link for a tire balancer… how hard is it to share the link fir those cheap balancer you keep bragging about.?!!!