For the installation process of BKS Balcony Glazing System, one of the side walls and the lower handrail are taken as the initial.
Upper frame profile is mounted to the ceiling through the holes drilled in the assembly process.
Lower frame profile is placed on the handrail and side column profile is assembled.
Wheeled panels are hung on the system through top and bottom plastic outlets.
Conjoining points of the base caps are adjusted through the screws on the upper frame profile.
Lower frame profile is fixed to the lower handrail, then the other side column profile is assembled.
In order to assemble the outlet glass panel, top and bottom plastics are removed first.
The brake is slid to the other side of the outlets apart from their hinges.
The outlet glass panel is placed in the system. The brakes are slid back towards the side column profile.
The outlet glass panel is adjusted and the brakes are fixed to the frame profile. Top and bottom outlets are assembled back to the frame profile.
System balance is checked once again, from the first to the last glass panel one by one.
The label on the profiles is removed.
Stopper is assembled.
The balcony shall be carefully cleaned in order to protect silicone seal from dust and dirt. Angle brackets are used for covering the system inside and outside.
Finally, the client is given explanations about how to use the system.