Bathroom sink plumbing installation

No video

Bathroom sink plumbing installation

Рет қаралды 272,665

Күн бұрын

In this DIY plumbing video, I’ll show you how to how to install a sink drain, plus how to install a vessel sink and wall faucet. This bathroom sink plumbing installation tutorial is easy to follow and will allow you to plumb a P trap and install a bathroom sink pop up drain on your own.
►SUBSCRIBE TO MY CHANNEL
www.youtube.co...
►TOOLS & MATERIALS USED (affiliate links):
· P trap with adapter amzn.to/32B7xud
· Trap adapter (if purchased separately from P trap) amzn.to/2MYGYbL
· Sink drain push pop-up assembly amzn.to/2MY4e9X
· Delta Trinsic wall faucet amzn.to/2PBYXYL
· Silicone squeeze tube amzn.to/33VboCR
· ABS cement amzn.to/35Uvsqw
· Laser level amzn.to/33Sqxo8
· Hacksaw amzn.to/2orEg6z
· Slip joint pliers amzn.to/2PtQSVM
►ALL MY TOOLS & GEAR
www.diymontreal...
►WRITTEN ARTICLE
www.diymontrea...
►MERCH, APPAREL & PLANS
www.diymontrea...
►Follow me on SOCIAL MEDIA
· Instagram / diymontreal
· Pinterest www.pinterest....
· Facebook / diymtl
· Twitter / diymontreal

Пікірлер: 85

@rachelvillatoro3626 2 ай бұрын

You totally rock!! You thoroughly explained it and saved my husband from agony when we were trying to figure out how to connect 2 pipes that were different in size. Thank you, my vessel sink is done 🙂

@brucejohnson5030 4 жыл бұрын

I was taught (long time ago, but it was a This Old House episode where they were actually doing real people's old houses :-) that you should use plumbers putty on the underside of the drain fitting where it rests on the sink and to NOT put anything on the threads. I've not had any issues with any of the sinks I've fitted that way over the years. A little jar of it from Ace Hardware lasts forever.

@DIYMontreal 4 жыл бұрын

I learned to use plumber's putty ass well years ago, but it seems from research more plumbers are using silicone now, so I gave it a try. It makes sense to me - less brittle over time than putty. Only time will tell!

@HiddenAgendas 2 жыл бұрын

Best explanation and walk-thru by far. Thank you. Most of the other videos has zero commentary, very vague, skips a few steps and droned out with loud music.

@tradz4199 Жыл бұрын

Big Thanks...really helped since I couldn't find the info I needed for ensure a proper seal of the drain to the sink...the original instructions only showed use of a flimsy thin rubber washer that spells leak city. I really liked the use of silicon to solve this concern.

@RVRayRay 4 жыл бұрын

Thank you!!!! I just replaced the pop-up drain on my rv bathroom sink. It was a quick & easy job, thanks to your video.

@DIYMontreal 4 жыл бұрын

Happy to hear it! Thanks

@CaptKaffeine 3 жыл бұрын

Nice and helpful installation video. I like how you explained the different washers, direction, and what was replaced in the p-trap kit versus P-trap adapter fitting into the wall.

@ileanamorales1384 3 жыл бұрын

Great visuals and above all, very clear instructions. Thank you so much 😊

@marthayolandadiaz8324 3 жыл бұрын

By far the most informative and well-paced video of all the ones I watched on this topic. Thank you for sharing your knowledge!

@DIYMontreal 3 жыл бұрын

Appreciate it!

@jean-marclariviere7618 4 жыл бұрын

brings back a lot of memory. Good thing that you copper pipe was well anchored in that back wall. Like i said, memories....good and, not so good. Great job as always.

@DIYMontreal 4 жыл бұрын

Oh man, whatever happened... does not sound good! lol glad mine went smoothly. That's not always the case with these things as you know!

@ejtakach 4 жыл бұрын

Great install video! I like your explanations where you go back and forth to show potential hiccups in the process.

@DIYMontreal 4 жыл бұрын

Thanks! There are always hiccups along the way so hopefully some of mine will help someone else in the same situation.

@martytruelove5026 2 жыл бұрын

THANK YOU for the direction and guidance...a refresher course sure helps.

@jamespostlethwaite3393 Жыл бұрын

One big mistake. You need a larger hole in the wood so that the washer attaches directly to the sink, not to the wood. You might get away with only the silicone seal at the top if the sink does not have an overflow but it should always have a watertight seal at the bottom.

@a40ark Жыл бұрын

Very clear and concise. Maybe you should offer a video about how to film instructional videos 🙂

@lolthien 4 жыл бұрын

Very basic, and exactly what I needed! Thank you!

@DIYMontreal 4 жыл бұрын

Great! Glad this was useful.

@ScrewballMcAdams 11 ай бұрын

Great, easy to follow DIY video. Very helpful. Thanks!

@RVILDOR Жыл бұрын

Very clear instructions. Thank you so much

@bofett74 Жыл бұрын

Very helpful right now. Thank you.

@RobertJKeller 4 жыл бұрын

Nice one! I’m saving the link to that faucet! Love it.

@DIYMontreal 4 жыл бұрын

Thanks! Yeah, I fell in love with the faucet. 😍

@richardbrunelle7517 4 жыл бұрын

Great job Marie! Love the way you utilized the small space, and the vanity came out beautiful.

@DIYMontreal 4 жыл бұрын

Thanks!

@woodywoods5373 4 жыл бұрын

Great job Marie!!! you make it look so easy you must have alot of patients:-)

@DIYMontreal 4 жыл бұрын

Ha yes, it took longer than I showed but thank you to the magic of video editing! Once you have the parts figured out it's easy! :-)

4 жыл бұрын

Hello there. Thank you for installation information of bathroom sink installation..

@DIYMontreal 4 жыл бұрын

Thank you, my pleasure

@5thpixel Жыл бұрын

nice!

@IEnjoyCreatingVideos 4 жыл бұрын

Great work on the bathroom sink and plumbing Marie! Thanks for sharing the video with us.👍👌😎JP

@DIYMontreal 4 жыл бұрын

Thanks! Plumbing is not something I often tackle, but it's so satisfying once you figure it out and get it done all by yourself!

@IEnjoyCreatingVideos 4 жыл бұрын

😎

@billm4560 4 жыл бұрын

Just like always another awesome video! 👏👏 Thanks for sharing Marie!

@DIYMontreal 4 жыл бұрын

Thanks Bill, appreciate it!

@cliffjohnson1977 2 жыл бұрын

Extremely helpful, thanks!!!

@jasono2139 Жыл бұрын

1:25 if you apply the silicon caulking to the thread of the rubber ring, aren't you then going to smear the caulking over the threads on the tailpiece? ...and you'll end up gluing your locking nut to the tailpiece? (which would make potentially removing it in the future nearly impossible) The tailpiece of the drain pipe that I just installed had no threads where the rubber gasket went (and thus didn't need any caulking!). It also used a special locking nut (much deeper than the one you used).

@ZolaBolingo 4 жыл бұрын

Ça devient de plus en plus intéressant

@DIYMontreal 4 жыл бұрын

Ah? Super alors! :-)

@jamesfagan2749 3 жыл бұрын

clear instructions thanks

@WadaGoodIdea 3 жыл бұрын

Great video! Beautiful bathroom😍

@nerinarangel 4 жыл бұрын

I did it!!! Thank you so much 😊

@DIYMontreal 4 жыл бұрын

Awesome!

@corkle1721 3 жыл бұрын

Nice tutorial. Very helpful!

@aha0022 2 жыл бұрын

Thank you for this video. It was extremely helpful... One problem I have with the installation is that there is 4" space between the p-trap and the sink drain. The pipe coming out of the wall is too low. What type of extension do I need to connect the p-trap to the drain pipe?

@jeanloreaud9282 4 жыл бұрын

Très joli travail bravo salut Jeannot 🛠🙂

@DIYMontreal 4 жыл бұрын

Merci!

@Itsaustinnnyo 3 ай бұрын

Do i need to wait for the silicon to dry for 12 hours before running water and testing for leaks?

@jagboy69 3 жыл бұрын

And where are the shutoff valves to this??????

@Nestrs 4 жыл бұрын

Nice work, Marie! (as usual ;-)

@DIYMontreal 4 жыл бұрын

Thanks guys!

@creativeartbyluvensky 3 жыл бұрын

Thanks man!

@NewHouseAsh 3 жыл бұрын

Very helpful. Where is the shut off valve?

@danp3808 Жыл бұрын

Is your ptrap 1-1/2”? And the drain is 1-1/4”? Is that why you needed that larger adapter ring?

@squeekhobby4571 2 жыл бұрын

Brilliant

@user-ix1cj6on2w 3 жыл бұрын

so nice vanity，does the water go everywhere when washing hands

@janh6639 4 жыл бұрын

Love the vanity unit and for sure going to do something similar in my reno but quick question.....what do you use on the walls. I love the cladding but curious if you bought it or routed a plank and painted. Looks awesome 👏

@DIYMontreal 4 жыл бұрын

This is store bought shiplap. Was thinking of doing it myself, but the finish on the was nice and smooth and prepimed, so I went for it

@robertocarcamo511 3 жыл бұрын

Mala la instalación, el desague no se fija a la madera con el tapón conico, si llegara a filtrar afectara directamente a la madera y se notara cuando ya este manchada, con moho y podrida. El tubo de desague se apreta con la goma conica y luego la turca conta el vanitorio y la perforacion tiene que ser mayor a la tuerca de aprete para que baje libre y se aplica un buen cordon de silicona para que el vanitorio quede estable y se pegue bien a la base de madera aislando cualquier filtración.

@raulgutierrez1093 2 жыл бұрын

🤔🤔No es plomero piensala! Eso es pura propaganda!🪐😎👍🍺

@nefeledanae4568 3 жыл бұрын

Great job! Please could you tell me what kind of material is the black one on the wall that you installed the faucet?

@Santos-ek8md 2 жыл бұрын

Great video😎 Are the sizes of pvc different from kitchen to baths?

@monisamontoya288 3 жыл бұрын

The faucet came with an overflow drain so I had to shop for another- I had no idea that drains cost that much. The vanity has a drawer that will intersect with the drain- how short can I cut the pop up drain to attach to a horizontal pipe before dropping to the p-trap ?

@hexane8 3 жыл бұрын

so. damn. helpful!

@davidvasconcelos9947 2 жыл бұрын

Forgot to sand the inside of the ABS piping you used for better bonding.

@rickymckinnon5393 3 жыл бұрын

Question. How do you stop the sink itself from moving or spinning?

@DIYMontreal 3 жыл бұрын

When you tighten the drain ring for underneath it essentially locks it in place.

@rickymckinnon5393 3 жыл бұрын

@@DIYMontreal I have a glass bowl and it still moves. I'll try some other methods but good video overall. Very clear instructions. Thanks for the reply.

@bobbyperez3718 2 жыл бұрын

Supposed to have valves in the back of the thing to turn it off in case something goes wrong I don't see no valves behind to turn the water off you didn't show me very much then thank you

@TheAtlasSupreme 4 жыл бұрын

Why can't I have friends like you?

@DIYMontreal 4 жыл бұрын

😊

@jungleman4800 2 жыл бұрын

What size hole did you drill for the drain hole?

@martytruelove5026 2 жыл бұрын

2" is plenty friend...unless there is a fitting.

@jacksplumbingvideos7147 4 жыл бұрын

Don’t use the tubular abs p trap kits use the glue on abs traps they work a lot better

@miguelperez-qk3no Жыл бұрын

What Brand is that Vanity.?

@DIYMontreal Жыл бұрын

Made it myself

@marlonhernandez8411 Жыл бұрын

Didn't like the idea of the pop up drain,not sure if want to get my hands on dirty water

@sonnymylovesosweat 4 жыл бұрын

And your floating cabinet will get wet and will gonna get destroy soon

@JF-fx2qv 4 жыл бұрын

You did okay, for a women lol. Now, the guys have another reason not to have plumbers crack. Wait! does this mean the ladies will have a plumber's crack? Hmm!

@DIYMontreal 4 жыл бұрын

Ha well I'm sure the ladies do, but I just tried not to show mine ;)

@JF-fx2qv 4 жыл бұрын

@@DIYMontreal Handy Women with a sense of humor too. Keep up the good work.