very noice,keep up the good work

Hello, I've finally received all the components required for the project. Upon testing, I encountered significant performance issues with my cluster. It was experiencing severe lag, with the speedometer dropping to 0 RPM and 0 KPH every 6-7 seconds before returning to the expected speed. Additionally, the left turn signals were activating randomly, and the image of the front left door on the cluster screen was also appearing intermittently, accompanied by considerable noise. This noise issue is particularly pronounced at speeds over 120 KPH, as a sound alert is triggered when the speedometer lags to 0 and then returns, resulting in this sound being activated approximately every 7 seconds. To mitigate this, I've disabled the blinker and door open notifications in the code. I'm curious if this behavior is typical for MQB clusters, as I've observed that PQ clusters do not exhibit this lagging issue. For reference, I'm using a Golf 7 5G1.920.730, an ESP32-C3-M1, and a Seeed Studio CAN Bus Shield V2. I have specifically integrated the Seeed Studio library into the project because it requires this proprietary library, although it uses the same functions found in the existing project's library. By the way, fantastic work in identifying those CAN addresses! Much respect!

I managed to get the GOLF MK7 panel to work, however the auto and low beam lights and the hand brake light don't work on the ETS2 and ATS, another thing that was a little confusing for me was installing the module to simulate the fuel