Bear Synchronized Hybrid Cam Timing Instructional
Рет қаралды 38,929
11 жыл бұрынThis quick video offers instuctions for determing if your cams are timed properly and how you should can adjust accordingly.
@bignappy504 8 жыл бұрын
I have an Agenda 6. I followed the directions in the video for bottom cam and it got worse. I'm about to untwist buss cable and see if that works.
@Sideshowbobx 8 жыл бұрын
Check your ATA, might just be that cable to the top cam got to many twist in, and the ATA might be a hind short due to this. Remove a few twist from the top cam cable and see if this improves the timing.
@dragonsmugla 11 жыл бұрын
Well I just timed my Method. Bottom stop was hitting first. Took 2 turns out of control cable as the manual instructed and it is now perfect. Should I go and put the control cable back where it was and then adjust the buss cable or just leave it?
@OfficialBearArchery 11 жыл бұрын
Do as the video suggests. Let us know if you have any other questions.
@jimmyraybeagle5815 7 жыл бұрын
i really admire bear archerys support always willing to help
@jeffreycamilleri4467 10 ай бұрын
After 3years use had a bad mismatch in cams timing. bottom stop was pressing too much and top cam had around 7mm gap.Followed instruction to this helpful vid by adding 3.5 twists on the bottom part of the buss cable.Both cables just touch at same time now!True manual suggests a different method
@figjam8282 11 жыл бұрын
Manual states if bottom cam hits first remove a twist from the control cable , which is correct? Add twist to buss cable as the video suggests or remove from control cable as the manual states?
@techobal 6 жыл бұрын
Hi,a have Motive 6;60#.Perfect Bow.Everything it's in the Spec.ATA,brass height,timing is perfect. The lower stopper touches the control cable, a little.The top stop stops in the cable itself, at the very end of the rubber.The lower stop contact touches the control cable and stops at the very beginning of the tire, touching the cam.It is obvious that the lower stop is thinner than the top stopper.I'm looking for advice.Camm lean?Good day
@dawsoncoates 7 жыл бұрын
Okay so I just bought a brand new Bear Traxx and know I have to have it timed and my bow doesn't even let off either!
@Fred-eg9sx 3 жыл бұрын
since this isn't a split yoke cam, I'm assuming the cam orientation will always be aligned?
@ThePatriotParadox 3 жыл бұрын
With timing and my bottom cam hitting first, add couple twist to the bus cable, which is your yoke cable right?
@fusionstar916 10 жыл бұрын
Bought a method brand new. Cam timing was way off.
@tommye407 8 жыл бұрын
The manual is correct not the video. Add twists for the top hitting first and remove/subtract twists if the bottom is hitting 1st.
@stl3094 10 жыл бұрын
hi,a have a game hover,can a put the hybrid cam on it ,tank .
MERRITT OUTDOOR
Рет қаралды 60 М.
Average Jack Archery
Рет қаралды 18 М.
Zolten hockey
Рет қаралды 440 М.