Ive done a spin test on one of my wheels and once spinning at max there was no tilt forward or bacward to cut it out. It spun up real speedy like until my arms got tired then, i lowered it to floor where it did a mega burn out through the floor surface snaking a burn mark filling the room with tyre burn out smoke, finnally it cut out. i saw another different wheel vid spin test go into over spin no stop until floor burn out. Id be prepared to have a wheel no stop spinning. A cradel to flip on side to engauge side angle cut out might be worth thinking about, just thought of it. Im not doing spin tests inside, if at all. Be sure to stand to the side of spinning anything. Wishing you nice success and to be well.

It's 6 o'clock in the morning), Hello Dawn !Who saved the cubes under the wheel? Are you or friends?))

sawed cubes on a stand.Martin sawed))

It won’t cut out 🫣

Maybe correct PWM in darknessbot?

to the test pilot for the ricky settings of the aircraft)) I'll press my finger up

Begode bip at 80% Did you correct DB (calculated) PWM to match?

dear! You need to stand on the side. I'm worried that the wheel well come off!

Dawn, when you set the power alarm using begode app say to 80%, then switch to DB and read the percentage , it will say 90. There is about 10 % discrepancy. I think its a bug in the DB that I use, android version.

I wouldn't want to rely on that PWM alarm, hope it gets updated.

Could it be that DarknessBot PWM computation is not aligned with actual wheel PWM? Like DarknessBot saying "Hey, I am computing 90% PWM already, beep now", and the wheel is saying "no we're not, we are at 80%, chill". at 7:19, speed reading is stuck at 91.4 mph even though it sounds like the wheel was still ramping up a bit. I could be wrong.