Ben's Workshop Journey #86 (Completing setup for cutting tenons)
Рет қаралды 281
2 ай бұрынUsing the adage, measure twice, cut once, I am making doubly certain that my setup for cutting the tenons on the bench router are just where I need.
@MakerBoyOldBoy 2 ай бұрын
As usual Ben is precisely laying out the intricate details in his careful planning. A successful project is only possible by this laborious process. This is the unglamorous bits of woodworking. Carry on, mate.
@benelliott8745 2 ай бұрын
Thanks, Gary. It does feel laborious at the moment.
@johnwelch2224 2 ай бұрын
keep up the good work ben perfection
@benelliott8745 2 ай бұрын
I'll try, John. Thanks for your support.
@TimPiggott 2 ай бұрын
A small rubber mallet is handy for micro adjusting the fence. It is also worth checking that the fence is fairly parallel to the t slot 😘
@benelliott8745 2 ай бұрын
Thanks, Tim. I keep forgetting these little things like mallets.
Ben Elliott
Рет қаралды 238
超人夫妇
Рет қаралды 46 МЛН
Sergio Outdoors
Рет қаралды 69 МЛН
Ben Elliott
Рет қаралды 57
Ben Elliott
Рет қаралды 277
Tomislav Tomasic Woodturning (Dodir Drva)
Рет қаралды 53 М.
Ben Elliott
Рет қаралды 291
超人夫妇
Рет қаралды 46 МЛН