Best Filament Dryer for 3D Printing? FixDry Dryerbox

Рет қаралды 3,291

Күн бұрын

Thank you to FIXDRY for sending out the FIXDRY 3D Filament 2 Spools Compatible Dryerbox for me to check out. It's important to keep your 3d filament dry in order to ensure good print quality!
Receive 10% off your order by using the code: "SHAYWAY10"
Get yours here: fixdryofficial.com/?sca_ref=5...
🔥 My 3D Printing Recommendations 🔥
Polymaker PLA PRO: amzn.to/3sx5j0V
Bambu Lab 3D Printers: bambulab.com
Eiobos Filament Dryer: amzn.to/3R0H70T
►MY GEAR:
Sony A7IV: amzn.to/3Kyt3IV
Sony FE 20mm f/1.8 G: geni.us/A6s4At
Rode PodMic: amzn.to/45Trr41
Sony ZV-1: geni.us/vISMwC
10,000mAh External Battery Pack: amzn.to/3YUlNw6

Пікірлер: 15

@RobertJohnsonLasers 2 ай бұрын

How easy does the rolls spin, to print while it's drying?

@josefdahari 5 ай бұрын

Ive been using his dryer for quite. It's in my opinion the best one out of all of them

@illudedCeption 3 ай бұрын

would it fit a 3kg roll ?

@lonewolfsstuck 5 ай бұрын

I have been using this dryer for about ~4 months. Love this thing. Only dryer that actually dries my filament. I primarly print PETG, Nylon and ABS and this is the only one that will actually dry for long term prints. I use this for my 3KG spools and my 1kg spools. Love this thing.

@Shayway 5 ай бұрын

Didn't even think about 3KG spools, this would be perfect!

@lonewolfsstuck 5 ай бұрын

@@Shayway Some of the 3KG spools dont fit but i have found most of them do just fine. If they don't fit its only by a small amount on the top and you can often get by with removing the air diverter from the bottom, but careful cause it can cause a hot patch on your filament and bind it all together.

@ohfr20 3 ай бұрын

So this will dry out nylon without any extra drying methods ?

@lonewolfsstuck 3 ай бұрын

@@ohfr20 I use it for Nylon. 70c at 24+ hours (If you set it to 48 hours it just stays on until you turn it off)

@ohfr20 3 ай бұрын

@@lonewolfsstuck alright so if I put it on 70c for 24hrs + ,a zip up enclosure and, use on a adv 5m how successful do you think that would be able print a nylon ?

@ThePrintHouse 5 ай бұрын

Dang. My fixdry lid was not that tight

@Shayway 5 ай бұрын

It's very snug for sure! Also, love your vids! Thanks for checking out the channel!

@ThePrintHouse 5 ай бұрын

@@Shayway Yeah I think the snug fit isnt necessarily a problem, but it is odd. Especially with no handle. And thank you!!! I have huge plans for 2024 :D And of course man, just found you! Ill be sure to watch more :)