All the sensor went haywire and it doesn't take off
Пікірлер: 14
@5GDolla Жыл бұрын
When you start it, one of the propellers may be damage due to odd sounds. Level all motors in the middle.
@temesawsig64916 ай бұрын
I have the same problem, if you're drunk does that what I recommend doing is putting a black and white motor in the top right, a red and blue with the top left corner, a red and blue bottom right corner, and a black and white in the bottom right
@NotEvenThatsOdd3 ай бұрын
Pretty sure you put a clockwise propellor where a counterclockwise propellor was supposed to go. I was pulling my hair out on mine until I realized I forgot to replace one of the propellers on my son’s drone.
@pavelryabchuk48762 ай бұрын
Thanks it helped me solve my problem. First drone was making a high pitch noise, probably one prop was damaged. I replaced all 4 at once and screwed up the order :)
@skairkrow98008 күн бұрын
I just bought the BetaFPV Cetus with brush motors. 2 questions, How do I upgrade to brushless? and what are the advantages?
@manwithgutz8 күн бұрын
Honestly you can't upgrade to brushless the flight controller is done different. Brush gets heat up you need to pause can't do continuous flying
@cosmicenderian722311 ай бұрын
Your motor has been pushed to far down pull it up alittle on whichever is crating the sound
@dewetbeyers23392 жыл бұрын
Hello. is it possible to fix it without replacing the board
@manwithgutz2 жыл бұрын
nope its dead ..
@sarpaige14 ай бұрын
What type of movie was that no disrespect 😢😅😊
@Lloyd_workshop Жыл бұрын
what motor did u used
@manwithgutz3 жыл бұрын
Checkout the betafpv board continuous blinking red kzfaq.info/get/bejne/jLSYZ9WoutbTYIk.html