this content is great man keep up the good work!!

New Achievement Unlocked.. SINISTER BRAKES!

Looking at getting this kit for my 2021 XRC Turbo RR. Did the OEM 15" wheels not clear? Thanks

I have a X3max RS - RR. I live in the mountains, and as stated, stopping power isnt the best. There is an obvious night and day difference between stock and what Agency has come up with in their kit. With the master cylinder problems and the brake fade noted, do you recommend this kit, or wait a little while to see if Agency comes up with a master cylinder and pre-bent brake lines that can handle those beefy rotors and calipers?

What grease did you use for the wheel bearings?

How can I get 1 of those big stickers with the skull??

Sir.....Im almost finished bleeding this AP big brake kit on my X3max turbo rr. My last wheelset wont fit. (caliper rub). I have bought new 4/3 wheels that will fit.....but Im very worried now, after reading ShockTherapy blog about geometry. Do you happen to know a 6/1 wheel model that will clear this kit well ? t.i.a......Paul

Nice

Noice🤘

Man those are sweet and great video. 2500! Man! I agree brakes suck but man! That’s a lot of cheddar! Great video though. Take care!

The numbers speak for themselves and the most important thing doesn't matter can it go but can it stop

What latex gloves are those?

ive never been this early watching a video

Waiting on the sas vid. Heck, I'll take any Dmax content at this point...

Torqued to spec...😂😂 More like how many ugga duggas?? The video interruptions weren't a coincidence..😆

GREAT VIDEO and well done.....however, speaking from experience, do NOT buy these breaks. I have them on my Maverick X3 RS X Turbo R and they are NOT that great. I have been doing brakes for over 40+ years on all make and models of vehicles and I know what I am doing. These were a pain in the a** to bleed and finally get all the air out. Once that was done I did the recommended "break in" suggested from Agency Power for the brakes. Once done, they did brake better than stock however not as good I would have though they would have done especially for the price you pay for them. I have also went through 2 master cylinders and here's why. The master cylinder will only handle so many FT lbs of pressure. These brakes are so beefy that the stock (OEM) MS won't handle the pedal force in a heavy braking situation. Here's why and it's a combination of things. 1. The MS isn't stout enough to handle the brake pressure applied to them for these massive brakes. 2. The stock brake lines are steel braded brake lines and will only handle a certain amount of peddle pressure. When you are applying maximum brake pressure, once the MS is at it's max and there is still more hydraulic pressure applied it has to go somewhere and where it goes is to the weakest point which is the embrace lines. What happens then is the braded brake line EXPAND (budge) out and you lose your braking pressure that should be going to the caliper. 3. Then when this happens, there is soooo much pressure that the MS cant handle the pressure and you blow the plunger seal and it will start to leak. Now, to remedy this problem is simple but time consuming. If you must keep running this very expensive system you will need to change out your brake lines to steel or copper solid brake lines which will put all the braking pressure at the caliper where it belongs giving you the maximum braking pedal for your buggy....but be careful, you can still "over pressurize" the MS.

Sweet brake kit. But $2500 ??? No thanks.