Billetworkz - 2019+ Hyundai Veloster N Short Shifter Install Guide

No video

Billetworkz - 2019+ Hyundai Veloster N Short Shifter Install Guide

Рет қаралды 4,116

Күн бұрын

Buy here: tinyurl.com/yr84ecyn
In this video, Austin runs through the installation of the Billetworkz Short Throw Shifter on a 2019+ Hyundai Veloster N. In this example, we use a Gloss Red Short Throw Shifter with our Tall Teardrop Shift Knob in Performance Blue.
Experience up to a 25% reduction in shifter throw, allowing for more precise and quicker gear selection.
#Billetworkz #VelosterN #HyundaiVelostern #HyundaiVeloster #ShiftKnob #Modifiedcars #Aftermarketparts #Shortshifter #Shortthrowshifter
•••
Contact Us Directly: Info@Billetworkz.com
✅ SUBSCRIBE at:
/ billetworkz
🎞TikTok: www.tiktok.com/@billetworkz?l...
📱 Instagram: billetworkz...
/ billetworkz
🤳 Facebook: / billetworkz
/ billetworkz
💻 Website: billetworkz.com/
•••
Founded in 2014, Billetworkz set out to offer quality customizations for car enthusiasts to personalize their vehicles exactly how they envision them. Seeing the opportunity to provide the market premium products without a premium price, Billetworkz aims to offer enthusiasts a wide variety of custom quality vehicle upgrades for various makes and models.
Since then, Billetworkz has worked to build on the passion of enthusiasts around the world to express themselves with their coveted vehicles.

Пікірлер: 12

@rickbeaver195 21 күн бұрын

Good stuff. I used this as a guide to remove my Turbo r-spec assembly. Thanks.

@sv7006 9 ай бұрын

I can't wait to install it this weekend!!

@stoompa5349 5 ай бұрын

Hey, I’m looking into getting one too. How does it feel?

@lilsaint6299 9 ай бұрын

Can’t wait to get this

@stoompa5349 5 ай бұрын

Did you get one? If so, how is it?

@noah22261 7 ай бұрын

I had to use a dremel to get the reverse lockout to slide up

@doublen675 7 ай бұрын

Any idea if the directions are similar to fit this in the Elantra N?

@matthewchulka8750 8 ай бұрын

Can I ask what size punch you’re using for the pin removal?

@ryanku468 8 ай бұрын

If it helps, I just used an Allen wrench (from a set, to get the right size) and took a hammer to it. It worked perfectly 😅

@matthewchulka8750 8 ай бұрын

@@ryanku468 that does help, thanks!

@ryanku468 8 ай бұрын

Do you actually need an angle grinder to remove the lock washer at 7:20?

@Billetworkz 8 ай бұрын

A small Dremel tool would be a suitable option, or you could also use a flathead screwdriver along with a pair of pliers; either of these methods should work effectively. We admit that we might have used a more powerful tool than necessary with the angle grinder, but a small Dremel equipped with a small cutting bit should do the job perfectly