Рет қаралды 16,979
Solving the yellow oil warning light on start up and diagnosing a bad oil level sensor on BMW E46 with N42/N46 engine.
I explain what red or yellow oil warning light mean, then I use INPA to check for codes. I get the following error:
27C3 CDKTOENS - Signal Oelniveausensor (TOENS)
with description:
Signal abgefallen
Testbedingungen erfuellt
Fehler momentan vorhanden und bereits gespeichert
Fehler wuerde kein Aufleuchten einer Warnlampe verursachen
I also explain a little bit how the thermal oil level sensor works. I tried to clean the oil from the sensor connector but that did not work. I then replace the sensor with a new one and the problem is solved.
Oil level sensor part number (N42/N46 engine): 12617501786
Buy Valve Spring Compressor Tool Kit for BMW N42/N46: bimmerzen.com/...
How to use the VSCT tool: • Using 3D printed tool ...
Fix oil consumption on BMW N42/N46: • BMW N42/N46 Valve Stem...
DISCLAIMER:
BimmerZen assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. BimmerZen recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of BimmerZen , no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not BimmerZen.