BMW Z4 35is E89 / N54 Oil service / Reset oil service interval

No video

BMW Z4 35is E89 / N54 Oil service / Reset oil service interval

Рет қаралды 4,443

Күн бұрын

Oil service and how to reset the oil service interval in CBS/iDrive on a 2013 E89 BMW Z4 sDrive 35is with N54 engine.
Part numbers (35is/35i):
- Filter: 11427953129
- Oil: 5W-30 Longlife-04
Model for 3D printed funnel: www.thingivers...
Buy 3D printed Valve Spring Compressor Kit for N42/N46: bimmerzen.com/...
Content:
0:00 Intro
1:13 Releasing the oil filter cap
2:34: Drain the oil & torque the drain plug to 25Nm
3:27 Remove and replace filter element and o-rings
4:54 Add 6.5L of 5W-30 Longlife-04 oil
6:10 Reset oil service interval
7:20 Outro
DISCLAIMER:
BimmerZen assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. BimmerZen recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of BimmerZen , no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not BimmerZen.

Пікірлер: 10

@thedoble Жыл бұрын

Wow that 3d printed funnel is awesome! I'll definitely make one of those.

@danieloeur7334 2 ай бұрын

Thanks for your video! I got a z4 35i 2009. My direction is very hard, can you tell me where is the emplacement to check the oil, I didn’t find it. For my Z4, this is an hydraulic direction and not an electric. Thanks for your help 😊

@teinspringz Жыл бұрын

Have you thought about putting something like a Fumoto Oil Drain Valve in place of the sump plug, then regular oil changes are less messy? Did you clean dripping oil in the undertray?

@BimmerZen Жыл бұрын

I haven't to be honest:) I'll check it out! I haven't cleaned the undertray, I don't think there is any dripping oil there...

@WayToManyAssassins Жыл бұрын

Hey bimmerzen Ive been loving your videos especially the N46 repairs. i have an E92 with an N46 with bad stem seals would you recommend running a thicker 5w 40w oil instead of 5w30 to reduce the smoke? Or would it not make a difference Thanks.

@BimmerZen Жыл бұрын

Thanks! You could try with 5W40 oil, improvement will of course depend on the state of your engine. Maybe try for one oil change and compare before and after. To be honest, when the valve stem seals are bad, the only proper solution is replacing them and after that do oil changes every 10.000 km or 1 year with LL01/LL04 spec oil.

@WayToManyAssassins Жыл бұрын

@BimmerZen Thanks, yeah i think the engine itself is still in good condition but the seals only blow smoke when i accelerate from a stop. There's usually a puff if i accelerate quickly. I do wanna get them replaced, but I don't exactly feel confident doing it myself and dont wanna pay thousands for labour at a shop.