Part 1 short general discussion, part 2 specific hardware and grinding for hot street sbc
Пікірлер: 7
@aintskairtolskol95202 жыл бұрын
it's 11 oclock mate hahahah finally someone not just trying to sell products for sponsors ,doing a great job in descriptions mate
@flinch6222 жыл бұрын
Typical chevy sits between 3 and 4 degrees installed - oil wants to run to the rear anyway, so chamfering that return and removing any casting ridges gets the most attention. I do like the idea of removing slop with tubes in those oil holes as you did as long as lifter bores get grooved.
@ShawnStjean2 жыл бұрын
I hesitate to groove lifter bores--more oil on cam, but more to run off into windage, too. Real tradeoff, no?
@michaellorenson29972 жыл бұрын
Excellent, thank you.
@rogerpaulll14517 ай бұрын
thats for roller lifters flat tappets need the oil