2 key take aways from this video which were IMMENSELY helpful was 1. where the plastic piece fit in as you put back the assembly and 2. to seat the gasket in FIRST before you push down on the assembly at the end. YOU saved me SO much time. thank you

The little o-ring visual was really important for clocking when I installed mine. Super good video

I like that you are careful at every step not to damage the parts you are handling and in general the care you take in making sure everything fits correctly. Great video among a sea of poor ones.

you deserve more attention to your channel ! short , clear voice , & points out every possible obstacle.

Now this is a great video ...!!! He actually shows the position how to grab it and how to pull it out and put it back in and explains everything in between this is how you make a video great job I gotta do this job on my car now....My pump is working fine but my gauge ain’t reading right hope it’s just a sender unit I need to do some troubleshooting check the omh reading on a meter...! What I like is he explained what others don’t explain making this job very easy now thank you very much

You are the man, man . I looked at your video a few times and caught on to new tricks..the best part is the seal.life saver

New to the channel. Loving it.

Internet 2.0 this guy is the man

Fantastic video, just continue the good job.🤩🤩

Helped me a lot. Thanks for the video.

I just replaced my E39 fuel pump yesterday based on this video .. thanks 🙏

Great video, my friend!

thanks man.. nice video.. Allah bless you

good vid. carefully cutting hose stubs with a box cutter along their length works good too :-)

Jarooo ... You have a beautiful mind ✌🏻🤪🤳🏻

A couple of things I would never buy from a salvage yard one being a used fuel pump, it's not worth the liability, if you're left stranded depending how far you are from home the towing charge will outweigh the cost of buying a new name brand pump like airtex, another is a water pump, you're just asking for trouble. I priced an airtex for my 2003 530i they're around 125.00.

good job thanks

Great video👍 hope this will fix my 2003 BMW 530i no start but crank

To kralju

شكرآ للتوضيح

Excellent tutorial. Are you a teacher?

thx for the vid. Anyone here with experience with a Magneti Marelli replacement pump, quality wise? Found out the original is Pierburg.

What o-ring size is in minute 5 something? Or oem number? I need one. Thanks

Will it be okay to just replace the fuel hose connected to the fuel pump housing? Cause mine broke into half and im planning to replace it

Basicallt putting my bodyweight on the seal and it wont go in

Я теперь понял что неправильно установил насос , после просмотра этой видео

I just replaced mine on a 1998 528i. The orange light does not come on when gas is low. Also, the car ran out of gas when the gauge is at a quarter. What did I do wrong. Thanks

Hello, my 528i fuel gauge is showing incorrectly. Should I replace this part?

Where i can buy a new quel pump with the relative level sensor?

So e39 have 2 fuel pump?

I dont like to dremel near fuel :)