Really ? No joke ?

@@bcs9972yes

Yes

Imaš pored čepa za sipanje antifriza na boci do hladnjaka mali plastični čep sa krstastim srafcigerom odvrneš i sipaš u bocu dok ne počne da izlazi na taj mali čep

Isto tako imaš jos jedan na gornjem crevu do motora

A radna temperatura mu je 100 stepeni a na 105 pali ventilator nikako samo vodu u njega inače si uprskao stvar😂

2 bleeding screws n46 engine takes ages to warm up i have the same engine one above the oil cooler and the water tank should take a bit of time i was afraid too

1.) Fill it up till water comes out of the bleeding screw (while having the ignition on, turn the vents to the hottest temp and the fans on the lowest speed) 2.) Close the lid and all the screws. 3.) Drive a bit around till the car is hot. 4.) shut the engine off and open die bleeding screw a bit (till water and/or air comes out), watch it for like 5 seconds, if air comes out keep it open till only water comes out. If water comes out close the bleeding screw. 5.) wait till the car is cooled down and you can open the main cooling screw (it really has to be cooled down DANGEROUS if its still hot!) if the water level is OK then you are finished, if not fill a bit in, repeat from step 3.

yes normal sound

@@alexanderchaikovsky8323 No timing chain problem?

for n46 engines

Normal

Normal sound, mine do same, and it has 160 000km, I love the sound of this motor by the way 🤩

Petrol

Xd