Thankyou so much just bypassed my brake pad sensors but fault was still lit, never knew you had to reset the light in those settings many thanks bud

Did brakes, new cross drilled rotors and ceramic pads with sensors, got the warning light(pissed me off), hit your tutorial no longer pissed off thanks for your excellent advice..🇺🇸

I appreciate the straightforward video and information without all the blah blah blah

Great walkthrough, thanks. Just changed my pads but now I think the sensor needs replacing.

Thank you so much for this video! They failed to replace mine also when I had my pads and rotors changed. Now, I can just do this myself! Much appreciated!

Super walk through, thanks a ton for this video. Had this exact issue

Thank you for the info. Really helped me out.

Thanks mate for the video this was exactly the problem on my BMW

Very helpful. Thank you.

Awesome vid man, really helps!

Just wanted to add for anybody searching for this: it could also be a curbed pin on the brake sensor connector. I replaced mine on a F31 along with brake pads and discs and it wouldn't reset in the dash. After checking the newly mounted connector, I saw one pin was not sitting straight. Straightend it carefuly, reconnected, reset worked (car on jacks, P brake tightend, brake pad service notification due for 300kms for info, you can read a lot on this reset not working because of brake on, etc).

Thanks a lot bro. U r life saver 😊

Thanks very helpful.

Thanks for the help sir!!

Many thanks..this video was very helpful

When putting on the new sensor did you take out the metal clip that was in the inside the sensor ?

Legend thanks!

will this work on 528 model

Hi, really good video, where did you buy the sensor? What's the part number?

I see the BRAKE word is still on on the dash. How do you get that to go out?

Wait until the $4 rubber gasket next to where your crankcase oil goes through a passageway in your alternator bracket fails Hopefully you can fix that rather than pay the dealer $700, LOL. Leave it to BMW to over engineer everything, dealer wants $200+ to change one on my wife's car, glad I saw this video. I guess putting an audible sensor that costs basically nothing in the brake pad was too pedestrian for them. Then they only put them on one side in front and back...

i changed my pads and had same issue of not willing to reset. Is there anything else beside the sensor that could cause this?

Didn't work for me. I had the brake pads and rotors and wear sensors and changed the brake fluid on all 4 wheels. Parking brakes work fine. Everything went well as expected. A week later I forgot to reset everything. I was able to reset all parameters except for the rear brakes. Now I keep getting a dashboard warning light to check my brakes. I even changed the rear brake pad sensor 3 times with new ones. My parking brakes were off at the time. I drive a 2011 X3 28idrive

I didn’t see your brake light turn off is it still on

I replaced the pads and the sensor but i cant reset the brake light message pops upp on the dash reset cant be done ?

I think you just have to unplug it and plug it back in.