If the car starts but stops after only a few seconds, one of the problems may be the particle filter clogging, Dismantling and cleaning may be a solution but.....
Пікірлер: 13
@GGG-xx8lf2 ай бұрын
did you have to loosen up the exhaust pipe behind it. I cannot get the DPF out .
@yev9210 Жыл бұрын
Thank you for the video. Can you explain how to navigate to perform this test in Ista+? I recently also cleaned my filter on 2014 328d and wonder if it was all in vain..
@JHAMS-007-car-repair Жыл бұрын
Watch this video kzfaq.info/get/bejne/aLlxpdFi1NfFcmg.html
@igortanyarascovschi12258 ай бұрын
thanks for your video. What did you use to clean your sensors? how it should be done? I dont want to damage them many thanks and await your reply please
@JHAMS-007-car-repair8 ай бұрын
After the sensors were removed, they were cleaned with a wire brush and then washed with brake spray. Be very careful with the electric wires so they don't break.
@igortanyarascovschi12258 ай бұрын
thanks a lot...By the way when putting back do you have the torque specs for every bolt? @@JHAMS-007-car-repair
@igortanyarascovschi12258 ай бұрын
torque specs for the sensors as well when putting them back????
@aamo105 ай бұрын
@@igortanyarascovschi1225check ista. It will tell you torque specs
@xxzmk6 ай бұрын
Do you know if there is a way to tell my F30 that I totally switched my DPF to a new one so the sensor doesn't throw the error all the time of 245700 and reduce my performance ? I haven't siwtched it yet but I can't find the option to reset the state in the BimmerLink or BimmerCode thing
@JHAMS-007-car-repair6 ай бұрын
Yes, a diagnosis can be made with ISTA where you can access the particle filter and reset it.
@kirwanjohn10110 ай бұрын
What did you use to clean the filter
@JHAMS-007-car-repair10 ай бұрын
Some services use anti-tartar solutions for bathrooms, I sent this filter to a company that deals with professional cleaning, from what I understood it was heated to 600 degrees Celsius, then the cleaning takes place with a certain substance, I don't know more, but the results are OK so far now.
@dompowa67055 ай бұрын
Hello im looking to do this job to my dpf , but i see at the end of video you got doubled the value why?