BMW F650 Funduro Problem with Carb.
Рет қаралды 15,388
Жыл бұрынI had nothing but problems with my carbs on my BMW F650 Funduro 1996 model. I ordered a repair kit that came with jets, o-rings and gaskets but since adding it all nothing but problems.
Eventually decided to strip it all back again and take a good look. Found out that these kits you can buy are rubbish. Different sized jets than originals and I even ordered another that arrived the same, different sizes and not consistent at all. My advice don't buy a cheap one!
In this video I show how to remove the tank and panels etc, plus removing and replacing the carbs. The bike now runs fine again :-)
@hdbkfl Жыл бұрын
Sir. You are the man! I have always been intimated by even touching a calburator, but you made it look easy. Thank you for making my quality of life better! Thank you, thank you..
@richardwhitehead4684 6 ай бұрын
Not having a garage, I also have to work in an old barn. Not ideal, but better than working outside. Fwiw, I just purchased a non running 1997 f650 and will pulling the carbs soon.
@bezpopisu Жыл бұрын
Finally I found out, which float mount in which carb - I spoke about the jet in the plastic float funnel. Thank you!
@PeterSmith-or3pq 3 ай бұрын
I've done this on my 98 f650 st . Little tricky ❤
@howrrmr.7172 Жыл бұрын
Happy 2023 with your 650!!
@motoarchery Жыл бұрын
Wooowww. I got lost in that carburetor with ya, mate. Motorcycle bliss. My 99 f650 is still going strong, but she's lately been chugging a bit at lower rpms. I know its time to get down to that carb. Thanks for the excellent video.
@user-hh9cu2px9g 15 күн бұрын
It’s a lot cleaner than the turd infested barn I have to work on my bikes in. And the critters (woodchucks and squirrels) will chew on the rubber stuff. Ugh. But like another commenter said, it’s better than working outside…
@pawekaminski7607 11 ай бұрын
Thanks for the movie. Wondered what is correct position of this short cable with a spring that opposes the throtle cable at the left side of carburetor. I have turned it one way and the other and don't know how it should sit now.
@rangie944 Жыл бұрын
Thanks for posting, good information there thanks. Did you change the venturi in the carbs?
@DJPresser Жыл бұрын
No, didn't need to so left it alone 🙂
@gerard3665 21 күн бұрын
Thanks for the video. You are a good mechanic. You don't clean the carburettors with ultrasounds and you don't do the synchronization with a special tool ? It is not necessary !
@DJPresser 17 күн бұрын
If you have an ultrasonic cleaner then yes do it! For balancing the carbs I just listen and ride until I’m happy.
@elioresmini6339 Ай бұрын
Hello, I have a consomation of 10l/100 with my f650 75km. Is it a carb problem for sur ? Thank you
@DJPresser 17 күн бұрын
Check to see if your carb is overflowing when you leave the fuel tap on. If yes then the floats are not working as they should.
@Creative-content24-7 11 ай бұрын
How many turns out is it on the air mixture screws pal thanks
@DJPresser 11 ай бұрын
I did 3 turns out. You can get to it once it's fitted back in if you hold your tongue in the right place!
@Creative-content24-7 11 ай бұрын
@@DJPresser I did 3 and half and just left it mate surly will be ok
@TINGVELL Жыл бұрын
did you try it out how was it
@DJPresser Жыл бұрын
Worked a treat thanks
Restoration Biker
Рет қаралды 18 М.
Nosov Iron Toys
Рет қаралды 23 М.
Restoration Biker
Рет қаралды 15 М.
Alain Nédélec
Рет қаралды 134 М.
planesofpaper
Рет қаралды 1,4 М.
Magic Mike the Mechanic
Рет қаралды 3,4 М.
Restoration Biker
Рет қаралды 10 М.
Максим Музыкант
Рет қаралды 1,1 МЛН
BullyPitTime
Рет қаралды 2,9 МЛН
DreaMs oF RezA
Рет қаралды 26 МЛН
ขอให้นอนหลับและฝันถึงโลกแฟนตาซีนะทุกคน
Рет қаралды 7 МЛН