Boat Owner Saved Thousands By Doing Restoration ...

Рет қаралды 11,440

9 ай бұрын

This is a question many boat owners have faced in the last few years. Is It Cheaper to do a restoration or buy a new boat. All things to consider when your looking at new boats .... is restoration cheaper. Our customer chose the restoration we even replaced the fuel tanks this catamaran should last many more years.
Watch as our team of experts meticulously assess, disassemble and restore the these boat/yacht projects. Join us in our journey to prove that with hard work, dedication and a little bit of magic, anything is possible. Don't forget the best compliment is to leave a comment and subscribe to our channel for more incredible boat projects!
Subscribe - / @willfixthat
Saved Boat Owner Thousands By Doing Restoration • Boat Owner Saved Thous...
Which Outboard Engine Did We Order For Our Center Console? • Which Outboard Engine ...
Never Imagined It Would End This Way 72ft Luxury Yacht • Never Imagined It Woul...
Boat is Sinking ... This Was The Worst ... • Boat Is SINKING ... Th...
If They ONLY Knew 72ft Yacht Burns to Waterline • If They Only Knew ... ...
Sinking Luxury Yacht Repairs Are Worse Then ... • Sinking Luxury Yacht R...
**NEW VIDEOS UPLOADED EVERY SUNDAY!**
Send all inquires to MobileMarineKW@gmail.com
So thru the years many of our clients have asked us how we "manage the chaos" of Our Boat Repair Businesses! Our videos are made up of projects we are currently work on! You may also see food and drinks sprinkled in since we LOVE to eat! 😁
We look forward to hearing from YOU leave us a comment below!
Thanks for watching, share, like and subscribe 😁!
#boatrepair #catamaran #glacierbay #boatrestoration

Пікірлер: 38

@WillFixThat 9 ай бұрын

What your opinion about buying a new boat or just restoring the one you have? This boat will be good for many more years. It was a lot of work but it will be like new when the owner is finished!

@RStout59 9 ай бұрын

Restore if you like the boat! You end up with a boat akin to your favorite car or truck that you continue repairing and taking care of. It is a satisfying endeavor.

@WillFixThat 9 ай бұрын

We agree! Plus lots of variables when deciding!

@marshallbrodie9974 9 ай бұрын

It is important to start with a quality boat. I am currently restoring my 1993 Intrepid CC. The transom, stringers and exterior gelcoat are still good even after 30 years. I was back and forth on the fuel tank install. I checked with Intrepid and they still foam the tanks in, so I am going to do the same. My tanks lasted nearly 30-years and the new ones should last.longer by glassing the top of the tanks. Given the price of new boats, it is economically advantageous to restore a boat, not to mention the environmental impact of disposing of a fiberglass hull. It is a lot of work though. I am replacing the tanks and engines. I am also re-gelcoating the deck and gunwales. I am also rebuilding the center console along with all new electronics.

@WillFixThat 9 ай бұрын

Much like our project boat ….. if the hull is in good condition & you’ve owned the boat a long time then you know how well it’s been taken care of! These fuel tanks were a bear to get out! They used 5200 originally to keep them in place! But, these are things you don’t know until you get into a job.

@marshallbrodie9974 9 ай бұрын

@@WillFixThat Lol, yes that's true. On my boat, they must have used two tubes of 5200 for the console. It literally took me a full week of hammering wedges and spraying Debond to get the console loose, and it still ripped some gelcoat off the deck.

@WillFixThat 9 ай бұрын

@@marshallbrodie9974 man that sucks .... that 5200 makes sense in the beginning but sucks later on when you want to do repairs!

@user-ji6sd3ou8b 4 ай бұрын

I’m rebuilding a 1993 2100 Hydra-Sports cuddycabin walk around with a Gil bracket 225 Yamaha 4 stroke t-top I’m having fun with it

@WillFixThat 4 ай бұрын

That sounds like a project too 🤣😀

@carldowney4177 2 ай бұрын

You always say trust but verify . Do you presure test all tanks before install even new ? I really like how you shop works

@WillFixThat 2 ай бұрын

Yes we pressure tested the tanks …. We have to cover our ass imagine if it leaked once put in? 🥴

@user-ji6sd3ou8b 4 ай бұрын

We used expandable foam,,, two part,,, and rubber straps

@WillFixThat 4 ай бұрын

That foam … be careful 🤣

@DrEd-th2lu 9 ай бұрын

My fuel tank welder/manufacturer told me to do several cow patty size 5200 piles and set the tank on top. I also have mounting brackets that were welded to the tank. It been about 5 years and no issues. With the cost of new boats today restoration can work out more cost effective…

@WillFixThat 9 ай бұрын

Yes hope you never have to remove those tanks cause those cow patties will be a bear to remove. Lots of variables when deciding to restore!

@johnfkeating 2 ай бұрын

That is not too bad for a fuel tank. Mine would be absolute murder to get out

@WillFixThat 2 ай бұрын

Unfortunately some are worse than others …. It’s not easy!

@johnfkeating 2 ай бұрын

@@WillFixThat totally get it. We love you and your husband’s channel. Getting others to watch!!!

@jrhamp 9 ай бұрын

Having had several boats slipped in Key West, it is nearly impossible to validate the quality and experience of boat repair issues...Assume $200.00 per hour for mechanics or electrical types.

@WillFixThat 9 ай бұрын

There’s lots of variables that play into a restoration!

@EastTNflyer 9 ай бұрын

Much cheaper to restore the boat you have and will be just as good as a new one. The cost of new boats is ridiculous. A 23’ Chaparral bowrider is over $80K!!.. I didn’t pay much more than that for my 2005 340 Sundancer.

@WillFixThat 9 ай бұрын

Have to consider cost and how long you have to wait for a new one! But, once the owner is done it will be as good as new 👍 or better.

@size-matters 9 ай бұрын

I just had to have the tanks replaced in my Pursuit 2870. The guy that did the work has done a lot of tanks. He coated the new tanks with epoxy. They will outlast me now.

@WillFixThat 9 ай бұрын

Tanks are a big job … depending how easy or hard they are to get them out! Thanks for sharing.

@HarryCane305 7 ай бұрын

I'm surprised you use the blue tape, green or yellow are what the cool kids use.

@WillFixThat 7 ай бұрын

We are the cool kids ... just depends on what your doing ... and what works for your job!

@jamesbageant8668 9 ай бұрын

I think a lot depends on if you need to repower. A pair of 150’s with digital controls is pushing $50K (as you know!). On a boat like this one, if you drop $60-80k in it, you’ll own it forever as you’ll be upside down on value. That being said, new boat prices have gone insane. A new Cobia 220, which is a 21’7” boat with a 4cyl 200hp lists for over $100k and sells in the upper $80k range. Insanity for a mass produced 21’ boat.

@WillFixThat 9 ай бұрын

Yes lots of variables if someone decides to restore. We didn’t mess with the motors! Your exactly right have to weigh the options.

@wstadlock 7 ай бұрын

Glacier bay is the cheapest water faucets, did they start building boats?

@WillFixThat 7 ай бұрын

not sure what you mean?

@wstadlock 7 ай бұрын

@@WillFixThat Glacier bay is the cheapest plumbing fixtures at Home Depot, in my plumbing history they corroded or failed the soonest. Just wondering if same company started making boats. That glue in fuel tanks without mechanical fastenings per your video, appears 5200 held.

@WillFixThat 7 ай бұрын

Thanks for clarifying… glacier bay for boats is out of business! Guessing different company. Yes that 5200 did its job! Made it very hard to remove.

@user-ji6sd3ou8b 4 ай бұрын

Sorry,,, for installing fuel tanks ,,, I have seen some strange things done on fuel tanks also

@WillFixThat 4 ай бұрын

lol yup been there on the fuel tanks! That expanding foam exploded on a boat one time! Years ago what a mess it does not come up easy.