bro... up all night trying to catch up. Did not realize you're showing the entire project. This is great! DAM YOU!

Honestly I’ve been sitting on my phone for the last 8 hours. I watched this from the start. I’m about to start ripping out the floor on mine and redoing the stringers and making some room for an underfloor tank is really stressing me out. I’ve fiberglassed before but I’ve never attempted doing stringers. Very helpful video though

1: Doesn't matter if the tank is level", it won't be level on the trailer or in the water. Also, the only time you know for certain what your fuel quantity on board is, is when the tank is "full" (at the gas pump). 2: The lack of ventilation around that aluminum tank can lead to serious corrosion issues in very short order. Use plastic. 3: Don't lay one-by's flat and expect to get a straight edge... 4: Fuel cells and fuel tanks are not the same thing though both store fuel. 5: Good luck.

Michael could you please send me the link for the rubber under the fuel tank Thanks, Gary Milner

Is 1/2" p'wood over the fuel tank going to provide enough strength for one or more folks standing on it? It's hard for me to tell from the video what the dimensions are.

where did you get the rubber from? Thanks

I'm sure you've mentioned it in another video but what type of plywood are you using?

Is there e reason that you don’t completely encapsulate the stringers in resin?

Michael...disregard my request as I have the answer from prior inquiries Thx