Boating Hack for Electric Trim Failure - How to Manually Lift An Outboard Motor

No video

Boating Hack for Electric Trim Failure - How to Manually Lift An Outboard Motor

Рет қаралды 26,678

3 жыл бұрын

I have been boating for almost 2 decades and just came across this life-saving hack. How to easily raise your outboard motor when the electric trim fails. Thanks for watching!!

Пікірлер: 26

@ffemtx47 7 ай бұрын

The yappity yappin stops at 3:40 and the "fix" begins at 3:43. You're welcome.

@londland5146 Ай бұрын

Thku...ughhhh

@gracechristianvideo Ай бұрын

Exactly. A 6-minute video that should've taken 45 seconds.

@eamonnocarroll5866 8 күн бұрын

Thanks - much appreciated

@michaelscheidell8210 2 ай бұрын

Thanks for the information I didn't know that I need to put fluid in my pump to see if it's my problem I have power to the motor but couldn't get to the motor

@bartmaka9520 Жыл бұрын

Thanks for the video my motor just died and i found your video your life saver

@jimmykastrinos312 4 ай бұрын

thank you, facing the same problem!

@JoseyWales845 9 ай бұрын

Great explanation. Thank you. That just what I needed to raise the leg manually.

@GlennConner 9 ай бұрын

Glad it helped. Thanks for watching!

@hanslepoeter5167 Жыл бұрын

thanks. That's good to know. I have a squeaky sound in the tilt, when i help it works but this will get me out of the water when it stops working.

@slowjamcdub Ай бұрын

Thank ya!

@budconner8197 3 жыл бұрын

Good information to know about thanks for sharing 👍

@russellgardner2557 Ай бұрын

Motor stuck in down position (Merc 115 Optimax) did hit the ramp coming out, but not bad. Got the boat home ... motor runs but will not tilt, suspect no/low fluid level. Cannot access the fill port and need to tilt motor up ... going to try this ..... Thx.

@russellgardner2557 Ай бұрын

Found the screw valve, motor went down further but to heavy for me to lift. I'm in a bind ...

@GlennConner Ай бұрын

@russellgardner2557 try a ratchet strap from a tree or another truck or something.

@ryanstanek1554 2 жыл бұрын

Awesome video, thanks

@gyulahohmann3123 Жыл бұрын

Awesome mate, gotta go work out where mine is located on my johnson 50hp coz they're all different , thanks mate 😎👍from Oz. Australia

@GlennConner Жыл бұрын

Should be pretty close to the same. I wish I would've know this. Would've saved me a couple hours on the boat ramp. Thanks

@chrisdriver4083 Жыл бұрын

Awesome man I didn't know that either

@JaredCarrica-tf2fd Жыл бұрын

Thank You!!

@chiefoutdoors Жыл бұрын

tried this with mine and i couldnt. felt like theres still pressure in it, but no oil came out. so im hoping the assemblty or something didnt break inside.

@amychartraw1 Жыл бұрын

It's not a "hack." It's a standard function on every factory hydraulic trim and tilt. Fyi, the parking brake on your tow vehicle is not an anti-roll down the hill "hack." Just sayin'. As an aside, if your skeg hits the ground while on thr trailer either the motor is mounted too low (you can google proper set height) or the trailer is setup wrong. Close is fine, but if your transom saver or other prop device fails going down the road you don't want to be able to drop anchor and plow a furrow thereby destroying your lower unit.