Рет қаралды 31,458
Congratulations on your new Bob PetHair Plus! Bob is ready to rid your floors of dust and grime with just these few quick steps.
Everything Bob needs for his first cleaning cycle is right in his box.
Install Side Brush
Before Bob’s first clean, you must install his side brush, which allows him to sweep along corners, walls, and other hard-to-reach places.
To do this, you will need the following materials, all of which are included inside Bob’s box: a side brush, a flat head screwdriver, and a short screw.
Flip Bob over onto a flat surface. Place the side brush over the empty socket on Bob’s underside.
Secure Bob’s side brush onto the socket using the flat head screwdriver and short screw.
Bob will chirp twice to let you know the sync was successful.
Charge Bob
Plug the charging adapter into the side of the charging station. The station’s red power light will turn on.
Place Bob on his charging station with the metal plates on his underside sitting on top of the nodes on his station.
When Bob is charging, the battery bars on his display screen flash and the word “charging” lights up.
When Bob has fully charged, the battery bars remain still and the word “charging” disappears.
Sync Bob’s Charging Station
Bob will automatically return to his charging station when his battery reaches 15% capacity, but first, you must sync him to it. You will only need to do this once.
To sync the charging station:
While the station is plugged in, hold down the SYNC button on the back of it.
While still holding down the SYNC button, flip Bob’s power switch ON.
Bob will chirp twice to let you know the sync was successful.
Sync Bob’s Remote
Bob will also need to be synced with his FullCommand™ remote to respond to its commands. Bob’s FullCommand™ remote operates on 2 AAA batteries, not included in his box.
To sync the remote:
Hold down the OK/SYNC button.
While still holding down the OK/SYNC button, flip Bob’s power switch ON.
Bob will chirp twice to let you know the sync was successful. If Bob does not chirp, repeat the process
Bob’s First Clean
Bob is now ready to clean!
Press the GO! button on his cover - or on his FullCommand™ remote - and he will clean on his default Deep Clean setting.
For more how-to videos, visit www.bobsweep.com.