Yes miss the older usa made tools 🔧

Hello again, Catus Maximus and Tiny Thank you for another Great Video 👍 Catus, you're amazing 👏

In the past I've taken lowly econobudget slip joints and: adjusted the joint; then put them in the vise and 'dressed' the jaw tips with a file till they'll grab/pull most anything off a flat surface. With some of them also touched up the cutters. It only takes a few minutes & can often (but not always) transform even the crudest 'Dollar Store' specials into somewhat useful pliers.

Nice old set of pliers and in great shape thanks Catus

Used a set of em to pull a cotter pin to change a belt on a bog standard Craftsman mower this mornin. Murica

I miss Sears Craftsman. Heck, I miss Sears. With these pliers, why did they put the nicer looking dome top of the bolt on the bottom? Just curious.

Looks like they have a typical HF manufacturing defect. Twix candy bars are made to tighter specs. Tractor tool box: slip joint pliers, vice grips, crescent wrench, flat blade screwdriver, hammer (if room).

Right on Good job love you From Dino Mares Fontana CA

Mr Maximus, Did you edit this video using these bog standard pliers?🤔 I ask this question because your trademarked "Catus Maximus here®" got left on the cutting room floor. 😹

Hello there?😂