ATE Brake Caliper Rebuild and Assembly after Repair and Painting Car: From Focus 3 ST / Kuga 2 - 320mm brake disk #brakecaliper #rebuild #assembly #fordfocus #restoration #carrestoration
Пікірлер: 22
@lcship1905 Жыл бұрын
Caliper refurb/paint job is spectacular 😊
@bobgreene28929 ай бұрын
Outstanding quality-- lighting, focus, and orderly procedure. (And we didn't have to listen to sub-standard music!)
@hamitinan6422 Жыл бұрын
normal gres kaucuğu bozar. silikon gres gerekli
@fred23hope68 Жыл бұрын
should have greased the slide pins.
@FreeKanal11 ай бұрын
No you don't lubricate those type of slide pins.
@Rockyboy12010 ай бұрын
Why not ?
@FreeKanal10 ай бұрын
@@Rockyboy120 The elasticity of rubber pulls these pins back and if you lubricate them, the lower part of the caliper will not go back as much as the upper part(because of weight) and the pads will wear slightly at an angle. These types of calipers should not be lubricated. These pins run dry, another story is with pins that works inside caliper these one we lubricate but with proper grease that doesn`t swell rubber. If we lubricate them with the wrong grease they may even seize.
@Rockyboy12010 ай бұрын
That’s interesting, I was not aware of that, thanks.
@ivan.bucher3 ай бұрын
treating this like a model airplane build...
@mullaway5746 Жыл бұрын
Need to grease the pins and the ends of the pads
@6wood Жыл бұрын
ATE company says they can't be lubricated. But why not.
@FreeKanal11 ай бұрын
You don't lubricate them.
@frundlemud Жыл бұрын
Piston goes in with a little brake fluid.
@Northwesternforcefield2811 ай бұрын
Or red tacky, since it’s a grease compatible with the dot four and 3
@dnacannotchange9 ай бұрын
Does rus😂😂t behind the square seal cause a leak because the rubber seal looks fine to me I'm looking at it right now
@peterzinia376711 ай бұрын
A little heavy on the lube. You only need the hit the inner seal & a little in the dust boot.
@emilianogabriel9613 Жыл бұрын
what kind of grease are you using because it will mix to brake fluid and fluid become contaminated its ok use that kind of grease
@ftsftw41811 ай бұрын
No never in my life have I seen this done
@armchairtin-kicker5037 ай бұрын
There is nothing absolute about using brake fluid. As I understand, red rubber grease may also be used.
@NABILSAQRAN10 ай бұрын
You need two weeks to finish one piston
@CryptoPaperRoute11 ай бұрын
omg you didnt grease the only thing that you should have THE SLIDE PINS!!!!
@ftsftw41811 ай бұрын
You Sure you know what your doing never heard of this