They use polymer now.

I have a few of the older Bravo Concealment holsters when Kydex was becoming the new thing. They still are holding up well.

I have bravo concealment which I like (iwb torsion). Light bearing i believe retention holds on to light more so vs non light bearing which holds the firearm (or could be the difference of design between the two). The upside down shake test in regards to retention you will notice with a weighted/loaded mag in the firearm as the additional weight (and gravity) there's extra weight to simulate draw pull strength. With no mag even lowest retention firearm isn't going to come out but with mag inside you will certainly tell the difference. Also, even though it is plastic, I found they do break in after you keep drawing the gun and will begin to tell some difference on retention levels as well (at least on non light bearing version).

Only critique I have is you did not show them on. It would have been nice to see how well they conceal.

Thanks Cody, I like BC so far. Been rocking it for a couple months now. Cant beat the prices for the quality you get.

I have 2 Fobus paddle OWB holsters for my G-23 and G-20. I also have one IWB skin holster which works for both… even in gym shorts. My Falco (Galco spin-off) is for winter carry for my G-20. All are fine. Also….. carry more than 9 milli for the mountains, Marine😬

Just found one of these concealment version for 30 bucks. Had to give it a try compared to the one I want that is 80

I think the reason that holster has some play is because it was designed for the tlr7a not the tlr 7 that your using in the video.

aswesome video mate. Very informative and well done!

02:08 I disagree with you, mine broke after a couple months of use and didn’t even bother buying a replacement, I stuck with the OWB holster and for my IWB I started using a $30 holster from amazon that has a much better belt clip! I will now go back and finish watching the video

Nice holster 👍

Is there a gap where the trigger guard is? Are you able to stick your finger in it?

What's the holster with the open bottom? I can't understand what you're saying.

I'm buying the OWB holster because u have to have a permeant to conceal carry if I buy the OWB can I buy latches for IWB an if so, where can I get them can u provide a link. This is for when I do get my permeant.

The polymer is not as strong as kydex, my 1 cracked near the slide as my belt was wearing down the polymer material

Good review. The holster, not so.

These holsters are lousy. Based on your review I bought 2 for a Glock 19 and a 45, both Gen 5. Neither holster fit neither pistol smoothly. They were stiff going in and extremely difficult to unholster, even when holding with your hands; forget about trying to actually use on your belt. I slid them in and out maybe a dozen times each and began to notice wear marks on my slides and they began to remove the serial number markings on my TLR7A’s.

this is not kydex

Hey Cody, is that a fake beard you're wearing? it looks like a Chinese kung fu movies with these guy's wearing fake beards? lol...

They’re new “link’d” holster is legit