Building a Mitsubishi Evo | Kiggly Racing Springs & Retainers Install!

Рет қаралды 6,184

5 ай бұрын

Building a Mitsubishi Evo | Kiggly Racing Springs & Retainers Install!
unfortunately we have to wait for the evo 9 kelford 272 cams to come in to finish off the timing belt service. Meanwhile we install the kiggly racing springs and retainers along side the BS Fab evo forward facing-manifold
racelegacy.com/shop/uncategor...
Parts supplied by @redlaneperformance
Camera Gear 📸 & Mitsubishi Car Parts 🔧
www.amazon.com/shop/migueldsm
Merchandise 👕
www.racelegacy.com/
Social Media ⏬
/ miguel_dsm
/ racelegacy
www.tiktok.com/@miguel_dsm?la...
Contact Email: Contact@Racelegacy.com
Spanish Channel 🇲🇽
/ migueldsm20
Mitsubishi Eclipse
Mitsubishi Evo
Mitsubishi 3000gt vr4

Пікірлер: 90

@ELROYJETSWAG 5 ай бұрын

Ive built plenty cars in my home garage including 3 evos just like this and theyre all still running tops. Just torque everything to spec, good tune and if the engine didnt overheat ya aint gotta resurface it. My father owns a machine shop we check heads and blocks everyday its rare that they warp unless they overheated, its just a customer preference which most do since its apart but not 100% needed. That motor will make a reliable 500 with what ya got, powerband is up top so wont be to much stress on the engine. Cant wait ta see it rippin!

@itsyaboi_dallas 2 ай бұрын

The fact you used an umbrella to finish what you could do kudos to you, bro. That's dedication 👏

@ill_sti4978 5 ай бұрын

I love how you do this out side your house no garage. doing the same with my evo man car is coming out bad ass!

@erikyanez6531 5 ай бұрын

You build your car your own way with the budget you have and we make the best of the situation with ours cars. I’m building my evo x currently in my garage.

@GhostDigital2k 5 ай бұрын

I can't wait for the EVO to be done. Good video. By the way I ordered some merch from your site. The VR4 and the eclipse stickers.

@MiguelDsm 5 ай бұрын

In due time 🙏🏼 Also, thanks for the support!

@GhostDigital2k 5 ай бұрын

@@MiguelDsm No problem!

@luisdavinci1023 5 ай бұрын

Love how the dogs are just chilling watching 😬

@MiguelDsm 5 ай бұрын

I’d love for them to pick up a wrench 😂

@jordansmobiledetailing5097 5 ай бұрын

Closing in on 100k! So glad you’re keeping the road and trucking along! 🎉

@MiguelDsm 5 ай бұрын

Getting there! Been a fun journey

@Ant-pu8cg 5 ай бұрын

Watching your content made me restore my Evo! Got it back to a running state, sent it to get repainted, got some TEs, next focus is some interior work. You, Devin, and Chris motivated me into restoring my Evo 8! Good lucky on your journey! Appreciate the process bc that’s the best part!

@MiguelDsm 5 ай бұрын

Dude awesome! Based of your profile pic it looks amazing!

@EvoAdventures 5 ай бұрын

You have an IG to follow?

@josepheaston551 5 ай бұрын

You’re absolutely right. Building a car yourself and taking your time definitely builds a bond. I did with my dsm and I couldn’t imagine not having it

@turbo_brian 5 ай бұрын

My ocd is going through the roof with you guys building that motor outside in the rain lol.

@MiguelDsm 5 ай бұрын

Gotta work with what you got lol

@shinzuel1466 5 ай бұрын

that dog was looking at you thinking who the hell is he talking too

@MiguelDsm 5 ай бұрын

They think I’m crazy 😂

@mikeydejon2148 5 ай бұрын

Keep pushing. I love this car looks great 👍

@1sikcavy2001 5 ай бұрын

Awesome work 💯 I'm the same way my build is slowly going.

@MiguelDsm 5 ай бұрын

Some progress is still progress! Keep on going

@user-tk3xj8ww2d 5 ай бұрын

Good job good job 👏😎

@cj41079 5 ай бұрын

Keep trucking along ❤

@MiguelDsm 5 ай бұрын

Always 🤘🏼

@DevonatSTM 5 ай бұрын

Love to see the progress. Reach out if you need anything!

@MiguelDsm 5 ай бұрын

Appreciate your help always man 🙏🏼

@kristjancebulj8162 5 ай бұрын

Hey man, big fan - you're a great inspiration to us eclipse owners so please don't take this the wrong way, but I feel like you could/should have done more while you were at it... I undestand budget, I'm dealing with the same situation as I write this, but it costs nothing to measure clearances and stuff when you are putting an engine together AND in the end it might even save you money. I hope you guys at least checked how the valves seal off-camera. That's just my 2 cents. Good luck with the build, great shots as always🫡🔥

@qreqeweqwee3682 5 ай бұрын

Napa aluminum brighterner on the aluminum will make the head look brand new again

@MiguelDsm 5 ай бұрын

Most common response im getting, thanks!

@cwestevo 5 ай бұрын

Keep it up!

@WILDWOLF_PRIME 5 ай бұрын

Progress 💯

@MiguelDsm 5 ай бұрын

Slow and steady wins the race

@okayplayer1911 5 ай бұрын

Aluminum brightener helps with make that head look new. 13:49

@leechamberlain5706 5 ай бұрын

Hopefully it works out.

@MiguelDsm 5 ай бұрын

Always does 🤙🏼

@EvoAdventures 5 ай бұрын

I wish I had that kind of motivation. Winter has me in a really bad head space.

@MiguelDsm 5 ай бұрын

Stay up man. It’s temporary 🙏🏼 Always free to talk just shoot me a dm

@cserrano-gi2if 5 ай бұрын

Those aren’t 625ca or l19 which are the ones you have to wear gloves with. Those are both silver almost look like stainless steel. The ones you installed are black which are probably arp2000s

@user-tk3xj8ww2d 5 ай бұрын

very good! 😎🎵🚘cool 😊

@marlonswaby8824 5 ай бұрын

First clean the head with purple power degreaser then with Napa Aluminum brightener that works for me.

@MiguelDsm 5 ай бұрын

Thanks!

@mahreeohhhh 5 ай бұрын

Link for the LED lights vid?

@brayanreyes5993 5 ай бұрын

Use aluminum brightener let it sit for a few minutes and rinse with water it will make aluminum look new, if you use a brush it will make the results better

@MiguelDsm 5 ай бұрын

Thank you!

@user-lu6nb6pj8n 3 ай бұрын

unless they hit the valve cap with a hammer. madhouse :))

@R19Robbin 5 ай бұрын

That intro clip 😬😂

@Wickd_lX 5 ай бұрын

Aluminum brighter to clean the head 👌🏾

@MiguelDsm 5 ай бұрын

Thanks!

@kordelwilliams5770 5 ай бұрын

❤

@chrishuber3814 5 ай бұрын

Dude, I gotta ask. Would you have attempted this if you didn’t gave the backup and it was just you?

@Cali1Sd 5 ай бұрын

Do some rear tail lights for the evo. Some like the gtr rings would be dope.

@MiguelDsm 5 ай бұрын

In the works 🤙🏼

@Cali1Sd 5 ай бұрын

@@MiguelDsm I’ll be in the look out.

@cesaralvarez6869 5 ай бұрын

You can’t use the cams on your eclipse ?

@MiguelDsm 5 ай бұрын

They’re Evo 8 cams and would leave the car not running

@josephnorman8657 5 ай бұрын

Try som alumi bright it works well

@MiguelDsm 5 ай бұрын

Is it paint? I’ll look into it

@josephnorman8657 5 ай бұрын

No its a cleaner you spray it on and let it sit and it deep cleans it and gives the aluminum a brighter look

@marlonswaby8824 5 ай бұрын

@@MiguelDsm No it's not paint just spray it on scrub a little if you want to and wash it off with water.

@_Machine631_ 5 ай бұрын

you dont need to wear gloves when handling 625's. the L19's are the ones that dont like oily residue and contaminents. 12:20 if you dont give that puppers head scritches pronto!!! haha. And these are the builds that are the best. where you have a smaller budget but you learn more. im loving the progress.

@MiguelDsm 5 ай бұрын

Gotcha. Good to mention just in case someone ends up with the L19s. Thanks or sticking along!

@pFbSpecV 5 ай бұрын

The worst part is the cost of what a new motor is gonna cost if you throw a rod pushing the limits of the stock motor 😢😢 but good content man! Keep it coming.

@MrPrince2289 5 ай бұрын

This comment 100% he thinks the machine work is expensive now. If that motor lets go, it's gonna be 3 to 4x as much. I understand he doesn't have the money. Maybe just keep saving,do it once and do it right. Hope it works out for the best for him. I'm not trying to seem negative, I just know from this happening to me.

@pFbSpecV 5 ай бұрын

@@MrPrince2289 yea I tried saying it in different ways on his other videos cuz I do like Miguel and he does help me sell my grounding kits so I for sure don’t mean to be negative also but dang….. these motors aren’t cheap when you completely need a block to rebuild lol

@MrPrince2289 5 ай бұрын

@pFbSpecV yeah sometimes you just gotta learn from experience. I got the same advice I'm giving now and I did the same thing he did. Said I don't have enough money, I'll do this and that and it should be okay. We all think "yeah it won't happen to me I'll be okay" then it happens. Funny thing is might pull when my engine let go I had a flashback of everything everyone was tell me, then I came back to reality lol

@lespaulguitarist92 5 ай бұрын

@@pFbSpecV miguel’s evo will be safe with a tune that limits its true potential.. but the results is: miguel’s evo will be slow for the turbo and upgrades he has because of that. Dealing with a laggy turbo that doesn’t make the HP to compensate for the lagginess.

@ELROYJETSWAG 5 ай бұрын

@@MrPrince2289 my 6466 2.0 still running 3 years later 515hp stock bottom end built head tuned by Raif RRT same set up as miguel just not bs fab manifold, granted it aint the fastest but it runs great an pulls hard. If the bottom end was solid from the start itll be all good. gotta build what yer budget allows pal

@br4eden 5 ай бұрын

day 2 of begging for eclipse content

@MiguelDsm 5 ай бұрын

Got a nice surprise coming next week 😉

@br4eden 5 ай бұрын

@@MiguelDsm hell yeah im hyped

@leechamberlain5706 5 ай бұрын

You have put the money in the wrong places.

@tmruffryd33 5 ай бұрын

Please elaborate, as an evo owner, id like to inquire

@leechamberlain5706 5 ай бұрын

@@tmruffryd33 What would like to know ?

@MiguelDsm 5 ай бұрын

Just like your opinion. It doesn’t matter 🫶🏼

@leechamberlain5706 5 ай бұрын

@@MiguelDsm Fair enough.

@tmruffryd33 5 ай бұрын

how would you approach a comparable build while keeping cost down?

@SofiaSclafani 5 ай бұрын

If you don’t mind me asking but what happened to your girlfriend Marissa, are you guys still together? I don’t see her being in the video no more.

5 ай бұрын

Am sure they not I’ve asked the same thing. He like lowkey hinted it in so many words.

@jethrox827 5 ай бұрын

He doesn't need her, he's got us 👍

@vzn5069 5 ай бұрын

He had stated in one of his videos that they are not together anymore

@manuelgarcia5175 5 ай бұрын

Did he end up moving to Mexico like he had mention ?

@vzn5069 5 ай бұрын

@@manuelgarcia5175 nah he was just going to go back and forth, i think the reason was because of his evo

@bcr1818 5 ай бұрын

DONT SAND THAT DECK! NO!

@ELROYJETSWAG 5 ай бұрын

its 400 grit do you not pay attention? you can sand it for a year straight it wont make a difference. That grit is used to prep cars before laying basecoat, it will leave a smooth finish with no gouging or gashing