I'm an independent contractor and I enjoy using your doors to install on shipping containers very reliable and good product

How do you’ re roll the Curtin if it unwound do to mistake ?

wish my old door here had one of those tensioners on the end. man, this things making wish I had a barn door instead. installing them brand new does look easy. way easier than what I am doing here with this 20+ year old door that messed up and needed repair it's all hardware that messed up. These doors require some " SOME" maintenance. Mine was here when I bought the house. The screws will back out eventually - my door is nearly identical to this one in the video but has no tensioner. The plastic guide parts on the sides of the door ( Not the tracks on my shed) are all Stapled into the door - cracked, broken, some pieces missing. The center DRUM that is in this video that the door is wrapped around when open is NOT on my door, instead there are just two metal stamped wheels that the axle goes through. they look like Cake Pans the edges are sharp and the inside edge on either one of them can slice your finger rtfo. LOL no joke. with no instructions and by myself, I have managed to take this down, revamp things to work, and then reinstall it. How? I have never seen one in person brand new so I came here and to other videos to see what they look like uninstalled. I slowly realized fixing my door was not going to be easy. The easiest safest way is to take the thing down to the point that the door is under no tension, completely down and the spring is unbolted < so zero tension on that Juggler ripper opener / Knuckle Gouger. do al your repair work with it this way so you don't accidentally kill yourself. To get to the inner tack and the outer edge plastics and to straighten out malformed edges I rolled it back up and took the door out of the tracks and rolled it out so both sides were exposed. This is QUITE A WORK OUT! my lats and forearms are feelin it. If I cared about teh looks more I could have repainted and completely refurbished but I dont.

Is this setup still working 2 years later?

I want to install one on the interior of a closet to replace typical 7h x 8w sliding closet doors... can the side rails be installed and then the roller installed after from the inside? Every install video I see there is ample room for the installation, wondering how this would go in a bedroom closet, seems possible but who knows?

At 2:32, you put the "Warning" yellow label over the top of the image of what should be done. It completely obliterates the intent of this close up and negates the whole attempt at showing and indicating a potentially dangerous installation mis-step. Please move the overlay so that at least we can see what you are trying to show.

Very Nice!

What is the correct height of the header?

That almost looked like the world famous Todd Nelson.

This is shown mounted on the hall side and not inside the unit.

Am I understanding this properly...that the latch is on the outside of the door? How in the world are you supposed to lock it? Padlock only?

For a 6x7 roll up, should your framing be 6x7?

what garage door openers can be used with this door?

👍

Ósea que no se instala adentro de la unidad.

buenas tardes; estoy montando una puerta de garaje enrrollable y me emite un ruido a la altura de 1m y no continua subiendo, me pudiese ayudar con algun comentario.

how about showing a video of mounting a motor door opener.

What's price of door ?

Can exterior weatherstripping be added to keep snow, bugs, dust, etc. out?

Es mas seguro poniendo los stoper antes de bajar la puerta para evitar que la puerta se devuelva y asi se agilisa la bajada de las puertas ya que se hacen en serie, toca bajar 300 puertas en un dia

What if I don't have seven feet?

H