i have some short questions. when all the 2d drawing is given in mm then is there any need to made the model in inches. means its confusing to co relate the ongoing video with that of the 2d drawing. 2nd 2d drawing is bit confusing too, means due to fillet clear boundries are not visible. 3rd 10 degree draft is not mention in the 2d drawing. these comments r not for criticisam. plz take it positively, i have learnt alot from ur videos. my aim is to improve my level under standing and level of ur videos as well. thanks

Sir should i learn everything about solidworks from your videos? Which playlist will you provide for.the beginner?

Thank you Sir.

I like your videos

Excelent

Sir please give orthographic projection too for practice

Can you plzzzz tell me which version of solidworks a beginner should use.

Plz design an air compressor using slider crank mechanism

@rajan If somebody doing hard work for the community then it is gud, if repetition is there then its all gud to repeat thing, u don't intrest then u shouldn't repeat that

Make 2d drafting videos in SOLIDWORKS

It has already been done. Repeating is no use for your fans.