This video shows how to adjust your waste gate rod on the Can Am X3
Пікірлер: 14
@dont4getatowel4 жыл бұрын
I’m thinking about purchasing the powervision 3 for my can am maverick x3 turbo rr loaded with the stage 2 tune from you guys off of Rpmpowersports it says to shorten the waste gate rod 2 turns from the stock position for the stage 2 tune so that is 2 complete turns? I run a ggb race exhaust and a rpm blow off valve and wanted to see if this tune is fine for my machine I normally use 93 octane pump gas.
@aftermarketassassins54914 жыл бұрын
Great to hear! Yes 2 full revolutions shorter is what you want. That tune will run great with your setup on the 93 octane fuel, they rip!
@reneulloa24374 жыл бұрын
How many turns on a stage 3 if you go shorter is that adding pressure? And is it better doing it like that than using the pressure pump gun that ive seen they use
@lalo_etz Жыл бұрын
i broke the peg🙄 any advice ? weld ? screw and nut?
@aftermarketassassins5491 Жыл бұрын
No good! We've not had this happen, so no direct experience.... but in other applications we use a shoulder bolt. Welding an new peg on would also work... if you can get to the back side.
@reneulloa24374 жыл бұрын
Is that set at 8psi on this video??
@el24najera3 жыл бұрын
How many turns for 1 psi
@aftermarketassassins54913 жыл бұрын
Roughly 1 turn for 1 psi
@marcogalaviz55743 жыл бұрын
@@aftermarketassassins5491 so if it’s at 7 and I need 8 I go 1 Turn shorter or 1 turn longer?
@aftermarketassassins54913 жыл бұрын
@@marcogalaviz5574 1 turn shorter would bring the PSI up
@pedromata9482 Жыл бұрын
I have a 18 172hp an tuned to 205hp what's the waistgate need to be?
@LOOKFAST3 жыл бұрын
You went 1 and a half
@DannyluxMx Жыл бұрын
How high it can go the oem
@aftermarketassassins5491 Жыл бұрын
10-12psi is about as far as we like to go as the throw is also being shortened.