Can I get it to run? (Working on Yamaha 25 outboard)

No video

Can I get it to run? (Working on Yamaha 25 outboard)

Рет қаралды 6,192

Жыл бұрын

Hey guys in todays video I got a sweet 25 rebuild for you. These are some of the most reliable motors and personally one of my favorites. Hope the vid helps you out and hope you enjoy it
Parts used:
Music credits:
Get Below Freezing by Daniel Gautreau and over 1M + mainstream tracks here go.lickd.co/Music
License ID: NrderaJ1A0v
Get Diamonds by George Georgia and over 1M + mainstream tracks here go.lickd.co/Music
License ID: pdWpGPr2jMO
Get Blunted by George Georgia and over 1M + mainstream tracks here go.lickd.co/Music
License ID: wWnV4Z1lmP5

Пікірлер: 32

@markusahlfors6132 Ай бұрын

I suggest throwing back those original float bowls in ur carb. The white ones that come with most of the carb rebuild kits tend to swell over time from gasoline and jam, causing flooding and all that👍🏻

@durbeshpatel3047 2 ай бұрын

Thanks for showing the carb rebuild in detail. Very helpful!

@outboardfinatic 2 ай бұрын

Absolutely thank you for the feedback!!

@davisreed149 Жыл бұрын

Great in depth look at rebuilding the carbs. Thank you!! Makes me wanna check out marketplace for some “dead” outboards.

@wheelinndealin Жыл бұрын

Nice work, rebuilding the carbs on one of these seems daunting. I’m just venturing into boats and doing my research this is good stuff keep up the great work👍🏻

@MunkyWrench Жыл бұрын

Great job man.. sometimes you gotta have faith and it pays off.. i got a mercury im doing on my channel now and a yamaha w low compression next.. keep up the vids

@chriseisele9969 10 ай бұрын

Great job as always you are very good teacher btw did you recheck the compression? Chris from OHIO gooooooo Buckeyes

@jean-sebastiennadeau5232 Жыл бұрын

Hey you're tutorial are along the very Best I have the same engine but a 20 hp. Up north outboard Last 50 years if maintained well those yamaha are gem

@outboardfinatic Жыл бұрын

Thank you I really appreciate that I hope it helped out

@sgtdrinkho 6 ай бұрын

Next time try removing and replacing carbs attached to the air box backing plate. You will have to loosen the pull rope assembly but easy all in one piece my friend. Great job

@outboardfinatic 6 ай бұрын

Hey thanks for this comment. I figured there was something like that that you could do but this was my first w these models so just went out on a whim lol. But now I know. Appreciate the feedback!

@scottpetrie8707 Жыл бұрын

Okay another great 1

@txsfisherman798 2 ай бұрын

I just got this exact engine, cleaned out the carbs. When I start it, it'll run, but suddenly, it'll do something that sounds like a cough with white smoke and squeak like a wheezing sound. It won't turn off, but it'll do that over and over every few seconds. All help is greatly appreciated.

@outboardfinatic 2 ай бұрын

That’s a lean sneeze. You’re not getting enough fuel to the engine one way or another. Basically too much air and not enough gas and they start doing that which they call a lean sneeze. May just need to adjust the carbs mixtures screw and it’ll probs fix your problem

@centralfloridahookset1252 5 ай бұрын

If you take the recoil starter off the carbs are way easier to get off you can just take it all off in one piece

@outboardfinatic 5 ай бұрын

Yea I think someone else mentioned something similar about doing that. Ima be doing that from now on as this was the first Yamaha 25 I’ve done a video for so greatly appreciate the advice and feedback!!!

@jakeryan3612 3 ай бұрын

Thanks

@BrokeBackBob4559 Жыл бұрын

Good video

@jenp 2 күн бұрын

Die you also clean the jets ultrasoon?

@outboardfinatic 2 күн бұрын

@@jenp I just used carb cleaner for the jets with a piece of wire to clean them out then I just blow air threw them all

@pucho513 Жыл бұрын

This is completely off topic, please forgive me, I have a 9.9 merc 4 stroke non bigfoot and I was wondering if the tell tale port can be removed and cleaned( area under thermostat)

@outboardfinatic Жыл бұрын

I mean it can but what’s the issue? If something’s clogged try dropping the lower unit and putting air pressure in the water pick up tube and feel of you can feel air out the tell tale

@pucho513 Жыл бұрын

@@outboardfinatic Thank you once again for the response and help

@sylvesterbahnam6573 Жыл бұрын

hey man love the videos where can I contact you have a couple question on my engine

@outboardfinatic 11 ай бұрын

I can answer qs on here for ya

@sylvesterbahnam6573 5 ай бұрын

I have a 90hp mercury 4 stroke sometime when I go from forward to neutral my engine shuts off or from reverse to neutral but not always thanks@@outboardfinatic

@luzdivina369eusou Жыл бұрын

Salve irmão aqui Brasil 🇧🇷🇧🇷🇧🇷🇧🇷🛥️

@timsussenbach5376 Жыл бұрын

I was like.... why are you rebuilding everything on that engine if you don't know if the crank is good.... cuz the crank seems rotten

@outboardfinatic Жыл бұрын

Not sure why you think the crank is rotten but did everything to make a video for you guys. It was a risk but it payed off. Runs perfectly fine. Never suspected a rotten crank or anything like as normally you’ll hear that pretty quickly. The rattling when it was on the water was the engine cowling. As it didn’t seal the best so it was vibrate unless I put my hand onto it

@timsussenbach5376 Жыл бұрын

@@outboardfinatic oh oke i'm not hating my guy... it just sounded like a bad crank with all the ratteling

@outboardfinatic Жыл бұрын

Yea I understand. But yea it was the cowling it didn’t latch the best. So it would vibrate like crazy with it on. But I didn’t show it in the vid but I could just put my hand on the hood and the vibrating would stop.