The picture is spectacular!

I have a 6 foot Farmking finishing mower that I pull with my Golden Jubilee and it does get really hot when the grass is thick and tall so I keep an eye on the radiator and make sure it’s clean so it can do it’s job and it does have a thermostat so I try to cut on cooler days with a nice breeze so it takes some of the heat away sometimes I can use 2nd gear and if I leave it to long I have to use 1st! But looks like you got a really good deal 😀🇨🇦

Nice. And rear discharge too. Ya, that tractor will have no trouble running that mower. I have a 1951 TEA20 Ferguson tractor and it runs a 6’ rear discharge mower. And we just recently put the 6’ mower on a Ford 1210 compact tractor. 16 hp diesel. And it runs it no trouble. Have a great week. 👍🏻🇨🇦

Great Video !!

I use my 8n with a 6ft side discharge finish mower. I think the tractor is all original, it pulls it but can't let the grass get to tall. The jubilee pulled it no problem.

You'll find it works better if if you use a PTO run down clutch, and extend your top link to allow the mower to float.

Did you replace your Oil Pressure gauge? If so, where did you get it? I have the original one that came with my tractor, but the line is leaking really bad behind the Hydraulic pump (the oil pressure line).

You need an over ride clutche so when you stop the tractor it will not push the tractor forward and sway arms to keep the 3 point hitch from moving side to side help out a lot.

I think you lost your job? Sweet running setup, looks and sounds good.

To all you saying ton get a overrun clutch its not a 9n 2n or 8n tractor, the mower will not push this model tractor, also they make a special pin for that mower that fits where you got those cheap bolts, they're like 7/8"

Some advice for someone who's owned that. Sell that toy tractor and mower and buy a zero turn. You can thank me later.