I haven't installed mine yet ;))

Hi.. did you notice that the alarm did not have a doors switch detected?

How to do, make it work..

@@mdtech7606 it has been 5 years. Not sure

Please email me to ven.limpakan@gmail.com thanks you.

What happens when the close button is kept pressed say for more than 5 seconds? Does it close the relay for the entire time or just sends a pulse?

mine somehow reloacks the car after some time when i run it, is it possible to stop it from relocking

I haven't mounted this either, I replaced the car.

What kind of shop can I take my car too my windows and locks are Manuel too I need this done !!

I never installed it...

@@furulevi alright, brother; you are a very humble man; that's a very good human trait.

I'm not sure, I still didn't installed this into a car.

there is usually a button on the box (M) labled and you hold that and the button to unlock on the remote so they cloud learn each code

Hello Steven, i have a 1995 Grand Cherokee. Maybe you can give me some installation tips? Where did you put the box? Which lines in the vehicle did you connect Box to? Do I have to go to the switch in the driver's door or do the cables run under the dashboard? Maybe with your help I can save myself a lot of time and unnecessary work. Thanks in advance . Martin

This gadget requires power... Add a solar panel to the car battery :)

@@furulevi The scope of your posting is to show various characteristics of this device. Adding a solar panel is another very complicated subject, but all decisions can be made if you contribute with correct measurements with your help, editing this video. I'm sure that way you will get more thumbs up.

@@furulevi 🤣🤣🤣

Did you have to had it programed? I just ordered One online and I was confused about if the chip comes programed or if I need to program it...

@@joanarodrigues4581 its very simple to do. Quer que eu explique em português ou en inglês Joana? Rsrs muito boa essa chave, é chinesa mas funciona muito bem, e ate é duravel, me cobraram 150 euros pela original, com 20, fiquei com uma chave mais legal q a original.

@@GuarujaBrazilGTASA-MP sim, também me disseram, mas o vendedor disse-me que podia ter de a programar... Eu vou mandar o mecânico instalar, mas para programar tinha de ir a outro sítio e não sei se eles programam este tipo de coisas... Mas eu vi muitos comentários a dizer que já vinha programada...

@@joanarodrigues4581 Joana, se tu pagar pra alguem fazer isso, não compensa, é bem simples instalar, e também codificar, ou programar, se for preciso, qual seria as tuas duvidas? Manja um pouco de elétrica? Eu mesmo instalei o meu, e meu parca viu, quis TB, hahaha, já instalei em 3 carros, e não tive nenhum problema.

@@GuarujaBrazilGTASA-MP a minha dúvida é só como codificar... Pelo que vi nas instruções não tinha como codificar...

I'm not sure...

i just found out looking at some other diagram that it can do both, in the Nr.1 diagram where you can ether hook up the yellow wire to +12v or minus thats what desides it, so in my case i need to hook the yellow wire to ground.

Press the learning button on the main unit for 3 seconds then press button on remote within 10 seconds.

I'm not sure, I never installed it, and there are no screws on the remote, so it probably uses plastic clips to hold it together.

I haven't installed this so I'm not sure what to tell.

inca nu am montat-o... ii brr afara ;)

Te inteleg :)) Pentru mine nu e o problema asta, doar ca nu stiu ce sa fac si speram ca m-ai putea ajuta tu..

Mi-ai putea da câteva informații cum sa o montez la motorașele din uși? Dacă mi-ai putea da un număr de contact ți-aș foarte recunoscător!!

Inca nu stiu cum sa-o montez... am uitat si ce am aratat in filmul asta si trebuie sa iau totul de la capatcea ce priveste studierea.

Am si eu una asemănătoare și nu mai functioneaza bine Știți ce ar putea avea?

I'm not sure, I haven't mounted this kit because I sold the old car that needed it and the new one already has it from the factory...

I haven't mounted it on a car...

I thought the same with the blue and green wires. In my situation the blue and green don't operate the door actuators, the red and blue wires do... I have five wire actuators...

it's not that simple... I haven't mounted mine yet :)

No, not to the fuse box. At most 3 of these 13 wires could be connected there, and it's always better to connect outside the fuse box than inside it. Where you do connect the wires will depend on where you mount the control unit. I installed the unit alongside the control module for my car's original central locking system; that provided easy access to +12v, ground, and the lock trigger wires while protecting the keyless system with the same fuse. I extended the light-flashing leads (brown) to reach the hazard-light switch; you could connect to the turn-signal wires from the steering column instead. You'll probably have to tap into the horn circuit at the steering column. Don't connect the horn lead (pink) directly to the horn! Your horn may draw enough current to overload and burn out the keyless module. If your car has a power trunk release, you can connect the keyless trunk lead (blue) to the interior switch rather than run a new wire all the way to the trunk. I think you'd have to wire the window-rollup lead (green) to close relays which in turn would supply current to the window motors; wiring all the motors to the green lead would sacrifice independent control of the windows. A wiring diagram for your car will help a lot to identify the connections.

I'm not sure what to tell, I haven't mounted mine yet.

I'm not sure, I haven't installed it...

@@furulevi Hmm do you have any idea about it? If it requires relay a connection like this one? :/ Sorry for been truble for you

I'm not sure...

@@furulevi its alright.... I think i might end up buying some keys and see if i can get them reprogrammed as long as they work with the right frequency

Sorry, but I haven't mounted my remote yet... I have another car now

i hav the same problem wondering it its not if the learning code

Not really... I haven't installed this yet into a car (I sold the old one and the new one already has this feature).

From your key ignition :))

I'm not sure, in the end I never installed this into a car.

A relay is needed to open the trunk, because it only has a transistor output which can be loaded up to 200 ma

Sorry, I haven't installed mine yet... I really should do it soon :/

Maybe if the physical key is lost or damaged than this wireless system could lock and unlock the doors.

Yes, it's edited, it is on 2x speed in the beginning.

I'm not sure, I didn't installed this one.

www.ebay.com/sch/i.html?_from=R40&_sacat=0&_nkw=Car+Keyless+Entry+System&rt=nc&LH_BIN=1

www.ebay.com/sch/i.html?_from=R40&_nkw=Car+Keyless+Entry+System&_sacat=0&rt=nc&LH_BIN=1

around 10$ ► www.ebay.com/sch/i.html?_from=R40&_nkw=Car+Keyless+Entry+System&LH_BIN=1&_sacat=75390&Features=Keyless%2520Entry&_dcat=75390&_sop=12

www.ebay.com/sch/i.html?_from=R40&_sacat=0&_nkw=Car+Keyless+Entry+System&rt=nc&LH_BIN=1

Find a local electronics or car parts store...

from 2:55 only :D

He did. You deaf?

after I studied it I talked :)

Well done. But I lost interest due to the lack of talking.

talking starts from 2:55 :)

Absolutely ZERO chance I'm going to watch a video for 3 minutes without talking.

I would talk much sooner.