@accord_aero_r 4 ай бұрын
You got so lucky with those toe bolts! I had to cut mine off because (like most CBs these days) they were seized into the bushing sleeve. Luckily they're still available new from Honda (part no. 52387-SE0-023). My only issue with these arms is that the longer LCAs aren't asymmetrical to allow for as much exhaust clearance. Because I don't have proper coilovers yet (just Tein springs on factory-spec struts), my suspension droops too low when on a lift. That means the arms touch the exhaust, and so my custom exhaust had to be routed to hang low to clear the arms at full droop. I'll have to have that section of the exhaust redone once I finally get coilovers. Something to consider for anyone else looking to get FFC's symmetrical arms.
@Canongang 4 ай бұрын
The left side was stuck from rust and I almost gave up that night but was able to hammer it out with a extension. I haven’t checked the clearance with my exhaust but I think it was close, I’ll check it out again tomorrow. I should of put anti seize on the bolt too 😫 the install was def a couple hours from a couple issues getting bolts back in and bushings sliding out but I’m happy with the results
@jaebonilla4594 4 ай бұрын
That looks awesome boss. Might have to pick this up!!
@Canongang 4 ай бұрын
🙌🏽🙌🏽 do ehhht
@lazeaylo.2718 4 ай бұрын
Can’t wait to build my 92 5 speed accord she’s clean and a beast 💯❤️👏😍
@Canongang 4 ай бұрын
🙌🏽🙌🏽
@L_ito 4 ай бұрын
a good upgradre bro chers!
@Canongang 4 ай бұрын
🙌🏽🙌🏽
Stauffer Garage
Рет қаралды 160 М.