CENTER TAP GUIDE with long action. It is an appropriate tool for manual threading
Пікірлер: 27
@gottmituns32253 күн бұрын
Nicule esti foarte tare in ce faci, te apreciez, BRAVOOOO, jos palaria ❗❗❗💪🏻💪🏻
@JIMMY9163 күн бұрын
@@gottmituns3225 Multumesc!
@JIMMY9163 күн бұрын
Sunt onorat pentru apreciere ! 👍
@pawekowalski74692 күн бұрын
Prosty i skuteczny projekt 👍
@JIMMY9162 күн бұрын
Dobry dzien ! I hope I have spelled correctly. Thank you very much !
@gottmituns32255 күн бұрын
AWESOOOOME❗❗❗
@JIMMY9165 күн бұрын
@@gottmituns3225 Thank you very much!
@JIMMY9165 күн бұрын
@@gottmituns3225 It means a lot to me. THANK YOU VERY MUCH!
@billsheehy16605 ай бұрын
Enjoyed that Thank You
@JIMMY9165 ай бұрын
Thank you very much!
@ÁREAJ275 ай бұрын
Olá amigo projeto muito bom guia excelente!!! Lhe desejo saúde e cada vez mais sucesso!!!
@JIMMY9165 ай бұрын
Thank you very much! All the best for you too, meu amigo !
@ÁREAJ275 ай бұрын
Obrigado amigo@@JIMMY916!Abraço
@iosifignat59725 ай бұрын
Impressive! you may develop your channel with more nice shots like this!
@JIMMY9165 ай бұрын
Thank you very much, my dear friend!
@briancarruthers17385 ай бұрын
Its only centering the rear of the tap with the quill. The cutting end could be missaligned by a large degree
@JIMMY9165 ай бұрын
I just show how it works. With a little attention, the alignament of the tap with the hole becomes perfect. For manual threading, I dont know a faster and more efficient method and I assure you that it is more difficult without tap guide center. Thank you for your comment
@user-fm1ff3mj1i5 ай бұрын
Bravo Türkiye den selamlar 🎉
@JIMMY9165 ай бұрын
Thank you for watching ! 🙋
@joellittle84865 ай бұрын
Seriously? Where did you find these guys.
@JIMMY9165 ай бұрын
Dont be a hater..!
@user-ip5oo3xn6m5 ай бұрын
🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣
@JIMMY9165 ай бұрын
😩😩😩
@dennistennyson88565 ай бұрын
Why didn't you clean the material up before putting it in the lathe ? You have a loy to my boy.
@JIMMY9165 ай бұрын
Thank you for your comment ! 🙆 Next time I will...
@raymondsanderson37685 ай бұрын
Uh, what? Sorry, I nodded off for a moment there!
@JIMMY9165 ай бұрын
If it doesn't happen often, you have nothing to worry about