If you do not have an indicator dial or you are in hurry, you can center the ROTARY TABLE on the milling machine with a very simple tool. There is not much to turn on the lathe.
Пікірлер: 6
@ÁREAJ27Ай бұрын
Olá amigo trabalho bastante interessante!!! Boa sorte sempre!!!
@JIMMY916Ай бұрын
I am honored, my friend !! Good luck too and thank you very much !!
@RB-yq7qvАй бұрын
Nice I think you foregot to click the collet into the holder correctly. Then try again for run out
@madmodder123Ай бұрын
yeah he didn't snap the collet into the nut and then insert it into the holder
@JIMMY916Ай бұрын
Yes, I was more concerned with the video and really forgot to tighten properly. After reading your message, I went to the workshop and redid the measurement and to my surprise the deviation is below 0,02 mm. Thank you very much for noticing this and sending it to me !
@JIMMY916Ай бұрын
Your are right ! Unfortunately, I was more concerned with filming and forgot this. Now , the deviation is below 0.02 mm. Thank you for your message and for your time !