I think there's a bit missing from this video. Where is the part about actually adjusting the distance?

Not very instructive, does loosening the swing arm bolts make the wheel drop back, what torque setting for axle nut. The video is useless really.

Meteor is the game changer 😎

Measure the distance from the swing arm bolt to the axle center. Or Set the near side adjustment to correct setting and with the offside loose, move the wheel to match the same setting and tighten. Count the lines from the punch dot and measure the swing arm to the axle. Use both measurements and check chain again.

Nothing about resetting the torque setting on the rear axle nut. I doubt also that that spanner with its limited leverage will loosen the axle nut off.

So the line marking on both sides should be same but from opposite direction,like in this video line marking on left side was between 3-4 from back and on 3 from front but on the right side ita totally opposite ,its between3-4 from front and on 3 from back. I didnt get it.

❤️❤️😘love it

Anyone can put a link which explains things better?

When will the new classic 350 be launched?

Price for custom windshield black??

Nice

Thanks.

Is it right that you use the markings towards the front on the right side and ones to the rear on the left ? as that’s what you have highlighted.

As it is shown it is a useless video, at what stage do you change the chain tension? And how?

How can I assign the same line marking on both sides?

Make same tutorials for Himalayan

I don't get it, you first loose the adjusters then tighten them, makes no sense 🤷‍♂

I followed this video and did well than a mechanic

First view

Absolute pointless.. You can be out at least one line on each side..

This video is so useless.... tell us what to do to adjust or thight the chain...

Nice