Love the opening music as you disassemble the machine. Just need Hayde singing along. Love their music. Excellent Norwegian Blue grass. Great job by the way. Thanks

from the Netherlands thanks for the video

Solderweld makes an Aluminum Repair Kit that we use in the Heating and Air Conditioning industry. We use them to Repair Micro Channel Condenser Coils which operate and hundreds of PSI. Should work well for your radiator which is well under those pressures. If it where to happen again that is. Either way nice Job👍

Great work brother 👍👍👍👍👍👍

I only tried pressure washing a radiator one time. Luckily it was on a parts car as the force of the pressure washer folded all the aluminum zig zags over by the large and would have cut off the air flow and cooling substantially. I was washing the rest of the car and did not really think about the radiator just giving it a once over. Lesson learned. Some of the heavy duty commercial styles are built with heavier gauge fins and will hold up better.

those bushings came out so easy due to good maintenance for sure. with no grease they would distort and make it difficult to remove

great work! you made that look easy! guess i really should do the same on my kubota

Great video! If you need high-quality Italian bushings straight from a manufacturer, give us a shout.😊

You got really lucky with those bushings, I thought you would have to press some of them out. Keep the old rad for a spare, just cut the tube in half where it is leaking and roll back the ends a couple of times and pinch with vise-grips. This should stop the tube from leaking and still have enough cooling from the rad. That mini is going to be like new when you are finished. Good job!

Looking good!

George Harrison - Got My Mind Set On You

Pity about the rad. A friend of mine used fibre glass to seal a hole in a rad before. I didn't believe it would work but there were no problems after. Chemical metal or the likes might of done too. It's all a gamble though 😄

I have repaired a radiator before by removing the entire damaged water tube and plug it off where it connects at each end.

Very good contents on the video i like the repair work, one thing that would make it better is if the camera would be in a tripod more often. I know its hard to film and do the work, keep up the good work.

Don't give up on the rad. Cut the one channel ths is leaking and fold both ends back on it's self. . Build a form around the two bent ends. Fill the cavity with jb weld so both ends are incased it the epoxy material. This will fix the rad.

Vi som ikkje e mekanikere savner videoer der du jobber......jobbvideoer :) Lage vei, mur osv er konge. Håper det kommer snart.....God Påske på etterskudd 😂

Funny how mutch we find so mutch more leaking or broke .when we get into a project !

Throw the bushings in the freezer before you install them. Big Jim

Biltema has some "universal" ones that can be made to fit just about anything, but I 'spose the closest one is in Tromsø, so still not to easy to get :P

No radiator repair shops where you live?

How much did you spend on all the pins and bushings?

Rads are pretty hard to fix, yes.

How much around for lavor I need to expend in replace all the bushings? Thanks

Jag lagade en ac kondensor med flytande kemisk metall på en volvo hjulgrävare provisoriskt i felsökningssyfte åt en vän för 10 år sedan, han kör den fortfarande med fungerande ac 😂 och den är det 10 bar tryck i så det verkar täta bra 😬

Hi, Do you know if we can increase oil flow on this digger?

Where did you get all the parts