Cheap DIY Tendon Joint For Windsurfer
Рет қаралды 395
Жыл бұрынIf you're like me and like to save a few bucks with a little elbow grease, I created 3 tendon joints for $17 (less than $6 each). In hindsight I could have made 4, which would have been about $4 each. Ordering one individual joint would run about $22.
@manuwindsurfing Жыл бұрын
Great find! Keep us updated with durability. Careful drilling through the base, holes may get enlarged. Also it's best to get a tight fit first as it'll get looser over time. The tighter the tendon the less stress on the holes. Offset the holes doesn't really affect durability. We just need to make sure that the base top and bottom don't rub onto each other causing added leverage against the tendon. Offset holes vary depending on brand.
@merzoutdoors Жыл бұрын
Thanks for the tips! I need all the help I can get.
@Hugomendesfla Ай бұрын
What is the hardness of the material (shore)?
@jpcuaycong7144 Ай бұрын
if this is polyurethane rod, what is the harness rating and size did you get?
@dee6816 10 ай бұрын
Where did you buy the material? What's the verdict? Has it been thoroughly tested?
@merzoutdoors 9 ай бұрын
No verdict yet.... Not enough wind around here! But I have fallen 30+ times and it hasn't broken (see my video how not to windsurf). Just bought online. Seems ok so far
@giuseppemeli Жыл бұрын
Ciao che materiale è
@Hugomendesfla Ай бұрын
Poliuretano
@cindyvanguilder8603 5 ай бұрын
It’s too long ! You don’t want the mast floppy , when you’re sailing
@merzoutdoors 4 ай бұрын
Thanks! What length should I use next time?
AnythingAlexia
Рет қаралды 30 МЛН
s4lt
Рет қаралды 1,7 М.
Charisma on Command
Рет қаралды 23 МЛН