excellent,clear and simple,informative-highly recommed,most helpful.
@hansstofberg43 Жыл бұрын
Just looked at a different video the only difference was that he used the lower valve as a flow and the top as a return for the anti freeze. I reckon it realy makes no big difference it will work both ways . Thanks for the clear explanation. Just had to fill our system after 8 years the pressure had gone to zero . There where some connections on my system that had sweated over the years you could see the green and black build up on the connections . I guess the installer had not tightened it enough because I could tighten it a bit more . Just got a cheap water pump with a maximum out put of 3 ato and a plastic drum of anti freeze. It worked perfect the pump is silent again
@markdurnin93842 жыл бұрын
What pressure should this system have reading on the clock when you close both filling taps
@K-carbon2 жыл бұрын
If your using a proper fill flush pumping unit it could finish up at 4 or 5 bar you den have to release the pressure Generally speaking 2bar and have the expansion vessel 0.3 bar lower than the set pressure 2 bar .Both temperature gauge need to be turns to 45 degrees to fill flush the system and then return them to vertical when finishs this gentleman has did a very poor job of describing how to service fill a solar system
@viciriuctoader84062 жыл бұрын
Ok felicităr
@knallaff6 ай бұрын
.... okey
@badmadmas3 жыл бұрын
Please don´t use automatic air vents on solar...
@K-carbon2 жыл бұрын
King span solar system never came with an automatic air vent this gentleman doesn't have much knowledge of this systems