Buys stainless exhaust, gets welded with carbon 70s2 wire. Gets mufflers installed, too quite, so cuts holes in exhaust in front of mufflers. I’m scratching my head....

The 2nd one, no contest.

Dood the battery isn’t dying & it didn’t sit too long in your shop it sounds like the guy has an aftermarket cam but didn’t want to spend the money for a tune brah ☹️

I’d have to say man, you’re a genius for starting this channel..

Man you guys do all the cool custom stuff! makes me want to move there and work for you guys! lol

The second Vette...the guy wanted more sound...simple take off the damn mufflers. Long tube headers and high flows cats with straights should sound damn good.

Nasty, lumpy welds, courtesy of Exhaust Addicts.

Not a fair comparison. Flowmasters in the kit are force II A SOFTER muffler. If he would have put super 10 or outlaw flowmaster would have won.

Keep practicing your welding.

Should of done the bypass mod instead of the cut outs.

Looks like someone sneezed on your exhaust. Ohhh wait, it was just your welds......

Someone give me a link to the manga flow exhaust

the guy that wanted it louder should just cam it/LT headers /straight pipe it (nocats/nomufflers),if that isn't enough sound for him IDK 😆

Both sound good though i think the Magnaflow had a better note to it.

Idk if this is why they put the cutouts but the benefit of not doing a muffler delete and just doing those cut outs on the magnaflow is less drone. If you look at a Borla ATAK for the hellcat it is literally a dual straight pipe but mufflers are attached on the side of the straight pipe - most of the exhaust exits straight out not entering through the muffler but some of the gases travel through the side into the muffler and this creates less drone.

Corsa extreme for corvettes there is no other option in my book

Flowmaster would’ve sounded a little louder if it also had long tubes on it. Imo. I’m a flowmaster guy

On that Magnaflow car, you could've bought the Borla S-type exhaust for far less money and it's louder, wouldn't need the turndowns. Since the Magnaflow was already bought and you wanted it louder, the proper way to do it is to bridge the inlet and outlet pipes, bypassing the muffler. Some of the exhaust bypasses it but some goes through it, and all of the exhaust exits the tips, not under the car. Look up the Z06 stock exhaust mod, lots of guys do that to get more sound and power but retain the factory titanium exhaust.

Magnaflow for the win

The flowmaster on the 1st vette sounded soft to me, but the magnaflows sounded better, and I am a flowmaster fan....

I’m normally a flowmaster guy however, that was the worst sounding exhaust possible. That poor guy spent all that money only to have his corvette sound stock. Totally wrong muffler for the application.

Basically owner with money vs owner with very little money lol

Yup as expected magniflow yeah buddy

Y'all got any videos with C6 corvette

KZfaq: 1 view, 3 likes Me: seems right and im first

Sure not apples to apples !! One with cut outs one without.

Wait 300 mph on the 2nd vet huh

Shoulda just put fake cut outs on the stock muffler lol, is this a joke?

Anybody know the wheels at 4:15

omg those welds are atrocious.

Where you guys located

You can’t exactly compare two cars with two completely different exhausts 😐

Come on now, they all need more sound

Putting an x-pipe to replace an h-pipe... 😂 🤮

those welds are horrible… i wouldn’t pay over $20 for those welds