Chevy Cruze master cylinder clutch replaced

No video

Chevy Cruze master cylinder clutch replaced

Рет қаралды 18,052

Cleber o negociante da america

Күн бұрын

Please don’t need to remove the two bolts E-12 on the top

Пікірлер: 18

@santoscamacho3361 Жыл бұрын

Thank you for sharing!..I have the same car and mine just went out on me!..saved me a lot of money!

@cleberonegociantedaamerica Жыл бұрын

You welcome

@atrevisi Жыл бұрын

Very useful Thanks!!

@cleberonegociantedaamerica Жыл бұрын

You welcome

@sbonisophakamani6256 3 ай бұрын

Hi sir I have the same problem and I changed the master cylinder but problem still persist like after replacing master cylinder it will engage first gear then when you try to go faster so that you will engage second gear it just stays on the floor and changing gears when you move slowly it's Diesel 2l Chevy Cruze LS

@cleberonegociantedaamerica 3 ай бұрын

I think you have air going to line check if you have leaks on the line

@sbonisophakamani6256 3 ай бұрын

@@cleberonegociantedaamerica Ok thanks will check as I just wanted to remove gearbox today but I haven't finished yet to take out the gearbox because the fly wheel was taken to engineering around April so wanted to check even the release bearing

@sbonisophakamani6256 2 ай бұрын

@@cleberonegociantedaamerica Hi brother I got the problem it was the release bearing inside the gearbox it was leaking so I replaced it and the car is fine now 🤝🤝

@cassiehill6318 15 күн бұрын

At 3:35 you say to remove the top hose, but you don't show it. I can't figure out how to remove it. Do you just pull it out? Do you need a special tool? Thank you.

@cleberonegociantedaamerica 14 күн бұрын

The hose I removed from the master cylinder I use the plier to remove the clamp

@cassiehill6318 14 күн бұрын

Oh thank you for the reply! I can't figure out what kind of clamp it is.

@Destroydification Жыл бұрын

hi, is there a need to bleed the braking system after the operation?

@cleberonegociantedaamerica 11 ай бұрын

No Just bleed the clutch system

@Destroydification 10 ай бұрын

How can i do that?

@joshuabarr6511 6 ай бұрын

@Destroydification same way as the brakes. Have someone pump the clutch and then hold it, open the bleeder, let air and fluid out, close it and then left off the clutch pedal. Top off master and repeat a few times

@sbonisophakamani6256 3 ай бұрын

And I did bleed the system sometimes it will clutch after few minutes it doesn't clutch