My next job. Got an old diesel Webasto that I'll repurpose 👍🏻

Brilliant. I want one...

You will have to be careful with the air intake underneath when you are going through water crossings as it will force water into the heater 👍

well done your doing a great job. You may want to move that fuel pump outside though, it'll drive you two nuts. I've slept many nights in trucks with these and in the dead of night its 10 times louder

Just what you need on those chilly nights. Nice install as well. 👍

Nice install, I like how you have utilised the space behind the seats, i have done the same with my electrics and water tanks 👍

Very nice install. I hope its gonna be reliable. Best Regards, David

Nice especially how the weather is just now 👍

when you put the diesel feed lines through the base plate, have you used a grommet to ensure that vibrations through the vehicle body don't eventually cut through the lines after some period of driving? Really enjoy watching you two and your adventurous driving ... and yes .. I have subscribed.🙂 Cheers and best wishes from 'down under' .. stay safe.

Great work there Jack 👍👍

Nice install mate. 👍🏼 I have one of these temporarily installed in my Paj for the winter but intend installing permanently in the summer so this is a great resource I shall be using, thanks for sharing. Whilst I'm no expert I would recommend getting a Carbon Monoxide sensor just in case and also with regard the fuel pump, the manufacturer suggest you fit it at an angle between 15° / 35°. Not sure why but thought I'd mention it.

Thank you for sharing. Cracking detail.

Stay warm :-) and safe. CO-Alarm is a must have. Best Regards and thank`s for share...

I've sussedd out some basic controller info... To change from the H 1-6 mode to degrees centigrade mode hold down top left button. To purge the pump press up and down arrows together and hold, letting go stops the purge. Holding down the top two buttoms brings up the timer icon, holding down the bottom two buttons brings up the timer adjust mode and on/off button to move through the values, but I've not played any further with this yet. For remote control pairing hold down together the on/off button and the down arrow and enter OC1and then press any key on the remote, press the top left button to exit.

Awesome! great content guys..

great luxury! , we put the same in our bivouac trailer, it's the best, you'll see how good it is. friendly Seb & Aurélie

Looks like its gonna work a treat. Couldn't tell from the video but how noisy is the actual heater and fuel pump?

I liked the bit 'hope nothing blows up'! It seems quite noisy, is it too bad?

Nice work! If you still have the pipes coming back from the engine bay you could add an egt cooler from a modern diesel (transit is cheap and good size for this) to the heaters exhaust and then circulate the engine coolant through it to preheat the engine. We all know how much old indirect diesels like starting when it cold!

I have just fitted a heater with the same controller, it is different to the usual lcd controllers and the buttons don't do the same as in the videos I've looked at. Do you have any instructions for this controller you could share please?

Which diesel heater is this? Where did you buy it again?

Hi, love the channel. Just a question regarding fuel costs on your trip to Sagres from UK. Is it crazy expensive?

Any reason you didn’t put the pump underneath? The diesel feed is underneath as is the tank so you’ve gone into the cab and back out. Also extend the air intake underneath so it’s doesn’t draw water when wading. I used to have an Ebpacher in a 110 and it’s was lovely looking at these Chinese ones for my current two landrovers