Basics on how to camber your Subaru! In this video I show you how I slot my struts for more front camber. Slotting the front is cheap and cost effective vs. buying front lower control arms. Keep in mind in the front, axle bind may happen once you pass -7 so if you're on air suspension, drive at a higher ride height to avoid axle bind. Also, I discuss how to achieve camber in the rear. For WRX/STI, the most you can push out from your LCA is about -4 before axle issues. Therefore, pulling camber with an upper control arm instead allows you to achieve more camber!
For FRS/BRZ/86 you can slot as much as you want in the front with no axle issues (RWD). For the rears you can push camber with just an LCA up until about -8.
Dremel I used: amzn.to/3l6nmI2
Dremel bit: amzn.to/3J6myKU
Hit that SUBSCRIBE button to stay up to date with my content!
MY CLOTHING BRAND ‘BRGS Supply’ 👕
brgssupply.com/
10% OFF SUBISPEED & FTSPEED 🏎
DISCOUNT CODE: ‘BRGSSTI’
www.subispeed.com / www.ftspeed.com
MY SOCIAL MEDIAS ⬇️
/ chrisborqes
/ brgs.supply
SEND ME STUFF HERE 📬
P.O. Box 212043
Chula Vista, CA 91921
AMAZON PRODUCTS I USE 📦
www.amazon.com...
MUSIC USED IN THE VIDEO 🎶
www.epidemicso...